diff --git a/Documentation/networking/driver.txt b/Documentation/networking/driver.txt
index a9ad58b..4f7da5a 100644
--- a/Documentation/networking/driver.txt
+++ b/Documentation/networking/driver.txt
@@ -37,7 +37,7 @@
 		...
 	}
 
-   And then at the end of your TX reclaimation event handling:
+   And then at the end of your TX reclamation event handling:
 
 	if (netif_queue_stopped(dp->dev) &&
             TX_BUFFS_AVAIL(dp) > (MAX_SKB_FRAGS + 1))
diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt
index 912e249..fd3c0c0 100644
--- a/Documentation/networking/ip-sysctl.txt
+++ b/Documentation/networking/ip-sysctl.txt
@@ -495,7 +495,7 @@
 
 	Note that if no primary address exists for the interface selected,
 	then the primary address of the first non-loopback interface that
-	has one will be used regarldess of this setting.
+	has one will be used regardless of this setting.
 
 	Default: 0
 
diff --git a/Documentation/networking/netif-msg.txt b/Documentation/networking/netif-msg.txt
index 18ad4ce..c967ddb 100644
--- a/Documentation/networking/netif-msg.txt
+++ b/Documentation/networking/netif-msg.txt
@@ -40,7 +40,7 @@
    Per-interface rather than per-driver message level setting.
    More selective control over the type of messages emitted.
 
- The netif_msg recommandation adds these features with only a minor
+ The netif_msg recommendation adds these features with only a minor
  complexity and code size increase.
 
  The recommendation is the following points
diff --git a/Documentation/networking/slicecom.txt b/Documentation/networking/slicecom.txt
index 59cfd95..5fb21d5 100644
--- a/Documentation/networking/slicecom.txt
+++ b/Documentation/networking/slicecom.txt
@@ -89,7 +89,7 @@
 
 -	-	no frame-sync, no signal received, or signal SNAFU.
 -	on	"Everything is OK"
-on	on	Recepion is ok, but the remote end sends Remote Alarm
+on	on	Reception is ok, but the remote end sends Remote Alarm
 on	-	The interface is unconfigured
 
 -----------------------------------------------------------------
@@ -257,7 +257,7 @@
 // No alarms - Everything OK
 //
 // LOS  - Loss Of Signal - No signal sensed on the input
-// AIS  - Alarm Indication Signal - The remot side sends '11111111'-s, 
+// AIS  - Alarm Indication Signal - The remote side sends '11111111'-s, 
 //	it tells, that there's an error condition, or it's not
 //	initialised.
 // AUXP - Auxiliary Pattern Indication - 01010101.. received.