ide: move IDE{FLOPPY,TAPE}_WAIT_CMD defines to <linux/ide.h>
While at it:
* IDE{FLOPPY,TAPE}_WAIT_CMD -> WAIT_{FLOPPY,TAPE}_CMD
* Use enum for WAIT_* defines.
There should be no functional changes caused by this patch.
Acked-by: Borislav Petkov <petkovbb@gmail.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
diff --git a/include/linux/ide.h b/include/linux/ide.h
index 55098ee..a9eced2 100644
--- a/include/linux/ide.h
+++ b/include/linux/ide.h
@@ -133,12 +133,28 @@
/*
* Timeouts for various operations:
*/
-#define WAIT_DRQ (HZ/10) /* 100msec - spec allows up to 20ms */
-#define WAIT_READY (5*HZ) /* 5sec - some laptops are very slow */
-#define WAIT_PIDENTIFY (10*HZ) /* 10sec - should be less than 3ms (?), if all ATAPI CD is closed at boot */
-#define WAIT_WORSTCASE (30*HZ) /* 30sec - worst case when spinning up */
-#define WAIT_CMD (10*HZ) /* 10sec - maximum wait for an IRQ to happen */
-#define WAIT_MIN_SLEEP (2*HZ/100) /* 20msec - minimum sleep time */
+enum {
+ /* spec allows up to 20ms */
+ WAIT_DRQ = HZ / 10, /* 100ms */
+ /* some laptops are very slow */
+ WAIT_READY = 5 * HZ, /* 5s */
+ /* should be less than 3ms (?), if all ATAPI CD is closed at boot */
+ WAIT_PIDENTIFY = 10 * HZ, /* 10s */
+ /* worst case when spinning up */
+ WAIT_WORSTCASE = 30 * HZ, /* 30s */
+ /* maximum wait for an IRQ to happen */
+ WAIT_CMD = 10 * HZ, /* 10s */
+ /* Some drives require a longer IRQ timeout. */
+ WAIT_FLOPPY_CMD = 50 * HZ, /* 50s */
+ /*
+ * Some drives (for example, Seagate STT3401A Travan) require a very
+ * long timeout, because they don't return an interrupt or clear their
+ * BSY bit until after the command completes (even retension commands).
+ */
+ WAIT_TAPE_CMD = 900 * HZ, /* 900s */
+ /* minimum sleep time */
+ WAIT_MIN_SLEEP = HZ / 50, /* 20ms */
+};
/*
* Op codes for special requests to be handled by ide_special_rq().