[ALSA] hdsp - Add DDS register support for RME9632 rev >= 152
Add DDS register support for RME9632 rev >= 152.
This register sets the sample rate for these cards and is required
in addition to the standard control register. It corresponds to a
quartz divisor.
Signed-off-by: Remy Bruno <remy.bruno@trinnov.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
diff --git a/sound/pci/rme9652/hdsp.c b/sound/pci/rme9652/hdsp.c
index 849ffe4..89b3c7ff 100644
--- a/sound/pci/rme9652/hdsp.c
+++ b/sound/pci/rme9652/hdsp.c
@@ -80,6 +80,7 @@
/* Write registers. These are defined as byte-offsets from the iobase value.
*/
#define HDSP_resetPointer 0
+#define HDSP_freqReg 0
#define HDSP_outputBufferAddress 32
#define HDSP_inputBufferAddress 36
#define HDSP_controlRegister 64
@@ -469,6 +470,7 @@
struct pci_dev *pci;
struct snd_kcontrol *spdif_ctl;
unsigned short mixer_matrix[HDSP_MATRIX_MIXER_SIZE];
+ unsigned int dds_value; /* last value written to freq register */
};
/* These tables map the ALSA channels 1..N to the channels that we
@@ -940,6 +942,11 @@
static void hdsp_reset_hw_pointer(struct hdsp *hdsp)
{
hdsp_write (hdsp, HDSP_resetPointer, 0);
+ if (hdsp->io_type == H9632 && hdsp->firmware_rev >= 152)
+ /* HDSP_resetPointer = HDSP_freqReg, which is strange and
+ * requires (?) to write again DDS value after a reset pointer
+ * (at least, it works like this) */
+ hdsp_write (hdsp, HDSP_freqReg, hdsp->dds_value);
}
static void hdsp_start_audio(struct hdsp *s)
@@ -984,6 +991,30 @@
return 0;
}
+static void hdsp_set_dds_value(struct hdsp *hdsp, int rate)
+{
+ u64 n;
+ u32 r;
+
+ if (rate >= 112000)
+ rate /= 4;
+ else if (rate >= 56000)
+ rate /= 2;
+
+ /* RME says n = 104857600000000, but in the windows MADI driver, I see:
+// return 104857600000000 / rate; // 100 MHz
+ return 110100480000000 / rate; // 105 MHz
+ */
+ n = 104857600000000ULL; /* = 2^20 * 10^8 */
+ div64_32(&n, rate, &r);
+ /* n should be less than 2^32 for being written to FREQ register */
+ snd_assert((n >> 32) == 0);
+ /* HDSP_freqReg and HDSP_resetPointer are the same, so keep the DDS
+ value to write it after a reset */
+ hdsp->dds_value = n;
+ hdsp_write(hdsp, HDSP_freqReg, hdsp->dds_value);
+}
+
static int hdsp_set_rate(struct hdsp *hdsp, int rate, int called_internally)
{
int reject_if_open = 0;
@@ -1092,6 +1123,10 @@
hdsp->control_register |= rate_bits;
hdsp_write(hdsp, HDSP_controlRegister, hdsp->control_register);
+ /* For HDSP9632 rev 152, need to set DDS value in FREQ register */
+ if (hdsp->io_type == H9632 && hdsp->firmware_rev >= 152)
+ hdsp_set_dds_value(hdsp, rate);
+
if (rate >= 128000) {
hdsp->channel_map = channel_map_H9632_qs;
} else if (rate > 48000) {
@@ -4945,6 +4980,7 @@
hdsp->irq = pci->irq;
hdsp->precise_ptr = 0;
hdsp->use_midi_tasklet = 1;
+ hdsp->dds_value = 0;
if ((err = snd_hdsp_initialize_memory(hdsp)) < 0)
return err;