OMAP3+: VC: use last nominal voltage setting to get current_vsel
Instead of reading current vsel value from the VP's voltage register,
just use current nominal voltage translated into vsel via the PMIC.
Doing this allows VC bypass scaling to work even without a VP configured.
Signed-off-by: Kevin Hilman <khilman@ti.com>
diff --git a/arch/arm/mach-omap2/vc.c b/arch/arm/mach-omap2/vc.c
index f53d1f5..21ffde8 100644
--- a/arch/arm/mach-omap2/vc.c
+++ b/arch/arm/mach-omap2/vc.c
@@ -138,7 +138,7 @@
volt_data = NULL;
*target_vsel = voltdm->pmic->uv_to_vsel(target_volt);
- *current_vsel = voltdm->read(vdd->vp_data->voltage);
+ *current_vsel = voltdm->pmic->uv_to_vsel(vdd->curr_volt);
/* Setting the ON voltage to the new target voltage */
vc_cmdval = voltdm->read(vc->cmdval_reg);