ath9k: fix beacon timer restart after a card reset
In AP mode, ath_beacon_config_ap only restarts the timer if a TSF
restart is requested. Apparently this was added, because this function
unconditionally sets the flag for TSF reset.
The problem with this is, that ath9k_hw_reset() clobbers the timer
registers (specified in the initvals), thus effectively disabling the
SWBA interrupt whenever a card reset without TSF reset is issued
(happens in a few places in the code).
This patch fixes ath_beacon_config_ap to only issue the TSF reset flag
when necessary, but reinitialize the timer unconditionally. Tests show,
that this is enough to keep the SWBA interrupt going after a call to
ath_reset()
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Cc: stable@kernel.org
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/beacon.c b/drivers/net/wireless/ath/ath9k/beacon.c
index 42171d0..b4a31a4 100644
--- a/drivers/net/wireless/ath/ath9k/beacon.c
+++ b/drivers/net/wireless/ath/ath9k/beacon.c
@@ -526,16 +526,13 @@
{
u32 nexttbtt, intval;
- /* Configure the timers only when the TSF has to be reset */
-
- if (!(sc->sc_flags & SC_OP_TSF_RESET))
- return;
-
/* NB: the beacon interval is kept internally in TU's */
intval = conf->beacon_interval & ATH9K_BEACON_PERIOD;
intval /= ATH_BCBUF; /* for staggered beacons */
nexttbtt = intval;
- intval |= ATH9K_BEACON_RESET_TSF;
+
+ if (sc->sc_flags & SC_OP_TSF_RESET)
+ intval |= ATH9K_BEACON_RESET_TSF;
/*
* In AP mode we enable the beacon timers and SWBA interrupts to