omap mmc: Add better MMC low-level init
This will simplify the MMC low-level init, and make it more
flexible to add support for a newer MMC controller in the
following patches.
The patch rearranges platform data and gets rid of slot vs
controller confusion in the old data structures. Also fix
device id numbering in the clock code.
Some code snippets are based on an earlier patch by
Russell King <linux@arm.linux.org.uk>.
Cc: Pierre Ossman <drzeus-mmc@drzeus.cx>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap1/board-h3-mmc.c b/arch/arm/mach-omap1/board-h3-mmc.c
index 0baba1c..fdfe793 100644
--- a/arch/arm/mach-omap1/board-h3-mmc.c
+++ b/arch/arm/mach-omap1/board-h3-mmc.c
@@ -12,13 +12,61 @@
* published by the Free Software Foundation.
*/
+#include <linux/platform_device.h>
+
+#include <linux/i2c/tps65010.h>
+
#include <mach/mmc.h>
#include <mach/gpio.h>
+#if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE)
+
+static int mmc_set_power(struct device *dev, int slot, int power_on,
+ int vdd)
+{
+ if (power_on)
+ gpio_direction_output(H3_TPS_GPIO_MMC_PWR_EN, 1);
+ else
+ gpio_direction_output(H3_TPS_GPIO_MMC_PWR_EN, 0);
+
+ return 0;
+}
+
+/*
+ * H3 could use the following functions tested:
+ * - mmc_get_cover_state that uses OMAP_MPUIO(1)
+ * - mmc_get_wp that maybe uses OMAP_MPUIO(3)
+ */
+static struct omap_mmc_platform_data mmc1_data = {
+ .nr_slots = 1,
+ .dma_mask = 0xffffffff,
+ .slots[0] = {
+ .set_power = mmc_set_power,
+ .ocr_mask = MMC_VDD_28_29 | MMC_VDD_30_31 |
+ MMC_VDD_32_33 | MMC_VDD_33_34,
+ .name = "mmcblk",
+ },
+};
+
+static struct omap_mmc_platform_data *mmc_data[OMAP16XX_NR_MMC];
+
+void __init h3_mmc_init(void)
+{
+ int ret;
+
+ ret = gpio_request(H3_TPS_GPIO_MMC_PWR_EN, "MMC power");
+ if (ret < 0)
+ return;
+ gpio_direction_output(H3_TPS_GPIO_MMC_PWR_EN, 0);
+
+ mmc_data[0] = &mmc1_data;
+ omap1_init_mmc(mmc_data, OMAP16XX_NR_MMC);
+}
+
+#else
+
void __init h3_mmc_init(void)
{
}
-void h3_mmc_slot_cover_handler(void *arg, int state)
-{
-}
+#endif