mtd: gpmi: remove line breaks from error messages and improve wording
Signed-off-by: Lothar Waßmann <LW@KARO-electronics.de>
Signed-off-by: Brian Norris <computersforpeace@gmail.com>
diff --git a/drivers/mtd/nand/gpmi-nand/gpmi-nand.c b/drivers/mtd/nand/gpmi-nand/gpmi-nand.c
index 31032b1..16a533a 100644
--- a/drivers/mtd/nand/gpmi-nand/gpmi-nand.c
+++ b/drivers/mtd/nand/gpmi-nand/gpmi-nand.c
@@ -285,9 +285,8 @@
geo->ecc_strength = get_ecc_strength(this);
if (!gpmi_check_ecc(this)) {
dev_err(this->dev,
- "We can not support this nand chip."
- " Its required ecc strength(%d) is beyond our"
- " capability(%d).\n", geo->ecc_strength,
+ "required ecc strength of the NAND chip: %d is not supported by the GPMI controller (%d)\n",
+ geo->ecc_strength,
this->devdata->bch_max_ecc_strength);
return -EINVAL;
}
@@ -1597,8 +1596,9 @@
dev_dbg(dev, "Transcribing mark in block %u\n", block);
ret = chip->block_markbad(mtd, byte);
if (ret)
- dev_err(dev, "Failed to mark block bad with "
- "ret %d\n", ret);
+ dev_err(dev,
+ "Failed to mark block bad with ret %d\n",
+ ret);
}
}