[SCSI] qla4xxx: add support for qla4032
This patch provides the following:
1. adds support for the next version of Qlogic's iSCSI HBA, qla4032
(PCI Device ID 4032).
2. removes dead code related to topcat chip and renames
qla4010_soft_reset to qla4xxx_soft_reset (minor changes).
Signed-off-by: David Somayajulu <david.somayajulu@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/qla4xxx/ql4_fw.h b/drivers/scsi/qla4xxx/ql4_fw.h
index 427489d..4eea8c5 100644
--- a/drivers/scsi/qla4xxx/ql4_fw.h
+++ b/drivers/scsi/qla4xxx/ql4_fw.h
@@ -296,7 +296,6 @@
/* ISP Semaphore definitions */
/* ISP General Purpose Output definitions */
-#define GPOR_TOPCAT_RESET 0x00000004
/* shadow registers (DMA'd from HA to system memory. read only) */
struct shadow_regs {
@@ -339,10 +338,13 @@
/* Mailbox command definitions */
#define MBOX_CMD_ABOUT_FW 0x0009
#define MBOX_CMD_LUN_RESET 0x0016
+#define MBOX_CMD_GET_MANAGEMENT_DATA 0x001E
#define MBOX_CMD_GET_FW_STATUS 0x001F
#define MBOX_CMD_SET_ISNS_SERVICE 0x0021
#define ISNS_DISABLE 0
#define ISNS_ENABLE 1
+#define MBOX_CMD_COPY_FLASH 0x0024
+#define MBOX_CMD_WRITE_FLASH 0x0025
#define MBOX_CMD_READ_FLASH 0x0026
#define MBOX_CMD_CLEAR_DATABASE_ENTRY 0x0031
#define MBOX_CMD_CONN_CLOSE_SESS_LOGOUT 0x0056
@@ -360,10 +362,13 @@
#define DDB_DS_SESSION_FAILED 0x06
#define DDB_DS_LOGIN_IN_PROCESS 0x07
#define MBOX_CMD_GET_FW_STATE 0x0069
+#define MBOX_CMD_GET_INIT_FW_CTRL_BLOCK_DEFAULTS 0x006A
+#define MBOX_CMD_RESTORE_FACTORY_DEFAULTS 0x0087
/* Mailbox 1 */
#define FW_STATE_READY 0x0000
#define FW_STATE_CONFIG_WAIT 0x0001
+#define FW_STATE_WAIT_LOGIN 0x0002
#define FW_STATE_ERROR 0x0004
#define FW_STATE_DHCP_IN_PROGRESS 0x0008