vxlan: fix receive checksum handling
Vxlan was trying to use postpull_rcsum to allow receive checksum
offload to work on drivers using CHECKSUM_COMPLETE method. But this
doesn't work correctly. Just force full receive checksum on received
packet.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/vxlan.c b/drivers/net/vxlan.c
index 0b95d5f..763061d 100644
--- a/drivers/net/vxlan.c
+++ b/drivers/net/vxlan.c
@@ -537,7 +537,6 @@
}
__skb_pull(skb, sizeof(struct vxlanhdr));
- skb_postpull_rcsum(skb, eth_hdr(skb), sizeof(struct vxlanhdr));
/* Is this VNI defined? */
vni = ntohl(vxh->vx_vni) >> 8;
@@ -556,7 +555,6 @@
/* Re-examine inner Ethernet packet */
oip = ip_hdr(skb);
skb->protocol = eth_type_trans(skb, vxlan->dev);
- skb_postpull_rcsum(skb, eth_hdr(skb), ETH_HLEN);
/* Ignore packet loops (and multicast echo) */
if (compare_ether_addr(eth_hdr(skb)->h_source,
@@ -568,6 +566,7 @@
__skb_tunnel_rx(skb, vxlan->dev);
skb_reset_network_header(skb);
+ skb->ip_summed = CHECKSUM_NONE;
err = IP_ECN_decapsulate(oip, skb);
if (unlikely(err)) {