Input: add driver for S1 button of rb532
Mikrotik's Routerboard 532 has two builtin buttons, from which one
triggers a hardware reset. The other one is accessible through GPIO
pin 1. Sadly, this pin is being multiplexed with UART0 input, so
enabling it as interrupt source (as implied by the gpio-keys driver)
is not possible unless UART0 has been turned off. The later one though
is a rather bad idea as the Routerboard is an embedded device with
only a single serial port, so it's almost always used as serial
console device.
This patch adds a driver based on INPUT_POLLDEV, which disables the
UART and reconfigures GPIO pin 1 temporarily while reading the button
state. This procedure works fine and has been tested as part of
another, unpublished driver for this device.
Signed-off-by: Phil Sutter <n0-1@freewrt.org>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
diff --git a/drivers/input/misc/Kconfig b/drivers/input/misc/Kconfig
index 806d2e6..203abac 100644
--- a/drivers/input/misc/Kconfig
+++ b/drivers/input/misc/Kconfig
@@ -238,4 +238,16 @@
To compile this driver as a module, choose M here: the
module will be called rotary_encoder.
+config INPUT_RB532_BUTTON
+ tristate "Mikrotik Routerboard 532 button interface"
+ depends on MIKROTIK_RB532
+ depends on GPIOLIB && GENERIC_GPIO
+ select INPUT_POLLDEV
+ help
+ Say Y here if you want support for the S1 button built into
+ Mikrotik's Routerboard 532.
+
+ To compile this driver as a module, choose M here: the
+ module will be called rb532_button.
+
endif