e1000e: 82571 Serdes can fail to get link
When link partner is sending continuous Config symbols, the 82571 Serdes
FIFO can overflow resulting in Invalid bit getting set. To resolve this,
if Sync and Config bits are both 1 ignore the Invalid bit and restart
auto-negotiation.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Emil Tantilov <emil.s.tantilov@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/e1000e/82571.c b/drivers/net/e1000e/82571.c
index 280d41fc..e57e409 100644
--- a/drivers/net/e1000e/82571.c
+++ b/drivers/net/e1000e/82571.c
@@ -52,6 +52,7 @@
(ID_LED_DEF1_DEF2))
#define E1000_GCR_L1_ACT_WITHOUT_L0S_RX 0x08000000
+#define AN_RETRY_COUNT 5 /* Autoneg Retry Count value */
#define E1000_BASE1000T_STATUS 10
#define E1000_IDLE_ERROR_COUNT_MASK 0xFF
#define E1000_RECEIVE_ERROR_COUNTER 21
@@ -1503,6 +1504,8 @@
u32 rxcw;
u32 ctrl;
u32 status;
+ u32 txcw;
+ u32 i;
s32 ret_val = 0;
ctrl = er32(CTRL);
@@ -1613,16 +1616,32 @@
e_dbg("ANYSTATE -> DOWN\n");
} else {
/*
- * We have sync, and can tolerate one invalid (IV)
- * codeword before declaring link down, so reread
- * to look again.
+ * Check several times, if Sync and Config
+ * both are consistently 1 then simply ignore
+ * the Invalid bit and restart Autoneg
*/
- udelay(10);
- rxcw = er32(RXCW);
- if (rxcw & E1000_RXCW_IV) {
- mac->serdes_link_state = e1000_serdes_link_down;
+ for (i = 0; i < AN_RETRY_COUNT; i++) {
+ udelay(10);
+ rxcw = er32(RXCW);
+ if ((rxcw & E1000_RXCW_IV) &&
+ !((rxcw & E1000_RXCW_SYNCH) &&
+ (rxcw & E1000_RXCW_C))) {
+ mac->serdes_has_link = false;
+ mac->serdes_link_state =
+ e1000_serdes_link_down;
+ e_dbg("ANYSTATE -> DOWN\n");
+ break;
+ }
+ }
+
+ if (i == AN_RETRY_COUNT) {
+ txcw = er32(TXCW);
+ txcw |= E1000_TXCW_ANE;
+ ew32(TXCW, txcw);
+ mac->serdes_link_state =
+ e1000_serdes_link_autoneg_progress;
mac->serdes_has_link = false;
- e_dbg("ANYSTATE -> DOWN\n");
+ e_dbg("ANYSTATE -> AN_PROG\n");
}
}
}