l2tp: Add L2TP ethernet pseudowire support
This driver presents a regular net_device for each L2TP ethernet
pseudowire instance. These interfaces are named l2tpethN by default,
though userspace can specify an alternative name when the L2TP
session is created, if preferred. When the pseudowire is established,
regular Linux networking utilities may be used to configure the
interface, i.e. give it IP address info or add it to a bridge. Any
data passed over the interface is carried over an L2TP tunnel.
Signed-off-by: James Chapman <jchapman@katalix.com>
Reviewed-by: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/l2tp/Makefile b/net/l2tp/Makefile
index 2c4a14b..bddbf04 100644
--- a/net/l2tp/Makefile
+++ b/net/l2tp/Makefile
@@ -8,3 +8,4 @@
obj-$(subst y,$(CONFIG_L2TP),$(CONFIG_PPPOL2TP)) += l2tp_ppp.o
obj-$(subst y,$(CONFIG_L2TP),$(CONFIG_L2TP_IP)) += l2tp_ip.o
obj-$(subst y,$(CONFIG_L2TP),$(CONFIG_L2TP_V3)) += l2tp_netlink.o
+obj-$(subst y,$(CONFIG_L2TP),$(CONFIG_L2TP_ETH)) += l2tp_eth.o