diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c
index 40dbe4c..ade483e 100644
--- a/drivers/net/e1000/e1000_main.c
+++ b/drivers/net/e1000/e1000_main.c
@@ -126,7 +126,7 @@
                                 struct e1000_tx_ring *tx_ring);
 static void e1000_clean_rx_ring(struct e1000_adapter *adapter,
                                 struct e1000_rx_ring *rx_ring);
-static void e1000_set_multi(struct net_device *netdev);
+static void e1000_set_rx_mode(struct net_device *netdev);
 static void e1000_update_phy_info(unsigned long data);
 static void e1000_watchdog(unsigned long data);
 static void e1000_82547_tx_fifo_stall(unsigned long data);
@@ -487,7 +487,7 @@
 	struct net_device *netdev = adapter->netdev;
 	int i;
 
-	e1000_set_multi(netdev);
+	e1000_set_rx_mode(netdev);
 
 	e1000_restore_vlan(adapter);
 	e1000_init_manageability(adapter);
@@ -900,7 +900,7 @@
 	netdev->stop = &e1000_close;
 	netdev->hard_start_xmit = &e1000_xmit_frame;
 	netdev->get_stats = &e1000_get_stats;
-	netdev->set_multicast_list = &e1000_set_multi;
+	netdev->set_rx_mode = &e1000_set_rx_mode;
 	netdev->set_mac_address = &e1000_set_mac;
 	netdev->change_mtu = &e1000_change_mtu;
 	netdev->do_ioctl = &e1000_ioctl;
@@ -2383,21 +2383,22 @@
 }
 
 /**
- * e1000_set_multi - Multicast and Promiscuous mode set
+ * e1000_set_rx_mode - Secondary Unicast, Multicast and Promiscuous mode set
  * @netdev: network interface device structure
  *
- * The set_multi entry point is called whenever the multicast address
- * list or the network interface flags are updated.  This routine is
- * responsible for configuring the hardware for proper multicast,
+ * The set_rx_mode entry point is called whenever the unicast or multicast
+ * address lists or the network interface flags are updated. This routine is
+ * responsible for configuring the hardware for proper unicast, multicast,
  * promiscuous mode, and all-multi behavior.
  **/
 
 static void
-e1000_set_multi(struct net_device *netdev)
+e1000_set_rx_mode(struct net_device *netdev)
 {
 	struct e1000_adapter *adapter = netdev_priv(netdev);
 	struct e1000_hw *hw = &adapter->hw;
-	struct dev_mc_list *mc_ptr;
+	struct dev_addr_list *uc_ptr;
+	struct dev_addr_list *mc_ptr;
 	uint32_t rctl;
 	uint32_t hash_value;
 	int i, rar_entries = E1000_RAR_ENTRIES;
@@ -2420,9 +2421,16 @@
 		rctl |= (E1000_RCTL_UPE | E1000_RCTL_MPE);
 	} else if (netdev->flags & IFF_ALLMULTI) {
 		rctl |= E1000_RCTL_MPE;
-		rctl &= ~E1000_RCTL_UPE;
 	} else {
-		rctl &= ~(E1000_RCTL_UPE | E1000_RCTL_MPE);
+		rctl &= ~E1000_RCTL_MPE;
+	}
+
+	uc_ptr = NULL;
+	if (netdev->uc_count > rar_entries - 1) {
+		rctl |= E1000_RCTL_UPE;
+	} else if (!(netdev->flags & IFF_PROMISC)) {
+		rctl &= ~E1000_RCTL_UPE;
+		uc_ptr = netdev->uc_list;
 	}
 
 	E1000_WRITE_REG(hw, RCTL, rctl);
@@ -2432,7 +2440,10 @@
 	if (hw->mac_type == e1000_82542_rev2_0)
 		e1000_enter_82542_rst(adapter);
 
-	/* load the first 14 multicast address into the exact filters 1-14
+	/* load the first 14 addresses into the exact filters 1-14. Unicast
+	 * addresses take precedence to avoid disabling unicast filtering
+	 * when possible.
+	 *
 	 * RAR 0 is used for the station MAC adddress
 	 * if there are not 14 addresses, go ahead and clear the filters
 	 * -- with 82571 controllers only 0-13 entries are filled here
@@ -2440,8 +2451,11 @@
 	mc_ptr = netdev->mc_list;
 
 	for (i = 1; i < rar_entries; i++) {
-		if (mc_ptr) {
-			e1000_rar_set(hw, mc_ptr->dmi_addr, i);
+		if (uc_ptr) {
+			e1000_rar_set(hw, uc_ptr->da_addr, i);
+			uc_ptr = uc_ptr->next;
+		} else if (mc_ptr) {
+			e1000_rar_set(hw, mc_ptr->da_addr, i);
 			mc_ptr = mc_ptr->next;
 		} else {
 			E1000_WRITE_REG_ARRAY(hw, RA, i << 1, 0);
@@ -2450,6 +2464,7 @@
 			E1000_WRITE_FLUSH(hw);
 		}
 	}
+	WARN_ON(uc_ptr != NULL);
 
 	/* clear the old settings from the multicast hash table */
 
@@ -2461,7 +2476,7 @@
 	/* load any remaining addresses into the hash table */
 
 	for (; mc_ptr; mc_ptr = mc_ptr->next) {
-		hash_value = e1000_hash_mc_addr(hw, mc_ptr->dmi_addr);
+		hash_value = e1000_hash_mc_addr(hw, mc_ptr->da_addr);
 		e1000_mta_set(hw, hash_value);
 	}
 
@@ -5070,7 +5085,7 @@
 
 	if (wufc) {
 		e1000_setup_rctl(adapter);
-		e1000_set_multi(netdev);
+		e1000_set_rx_mode(netdev);
 
 		/* turn on all-multi mode if wake on multicast is enabled */
 		if (wufc & E1000_WUFC_MC) {