s2io: Making LRO and UFO as module loadable parameter.
This patch adds two load parameters napi and ufo. Previously NAPI was
compilation option with these changes wan enable disable NAPI using load
parameter. Also we are introducing ufo load parameter to enable/disable
ufo feature
Signed-off-by: Sivakumar Subramani <sivakumar.subramani@neterion.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/s2io.c b/drivers/net/s2io.c
index 36937cb..063040b 100644
--- a/drivers/net/s2io.c
+++ b/drivers/net/s2io.c
@@ -401,9 +401,10 @@
* aggregation happens until we hit max IP pkt size(64K)
*/
S2IO_PARM_INT(lro_max_pkts, 0xFFFF);
-#ifndef CONFIG_S2IO_NAPI
S2IO_PARM_INT(indicate_max_pkts, 0);
-#endif
+
+S2IO_PARM_INT(napi, 1);
+S2IO_PARM_INT(ufo, 0);
static unsigned int tx_fifo_len[MAX_TX_FIFOS] =
{DEFAULT_FIFO_0_LEN, [1 ...(MAX_TX_FIFOS - 1)] = DEFAULT_FIFO_1_7_LEN};
@@ -2274,9 +2275,7 @@
struct config_param *config;
u64 tmp;
buffAdd_t *ba;
-#ifndef CONFIG_S2IO_NAPI
unsigned long flags;
-#endif
RxD_t *first_rxdp = NULL;
mac_control = &nic->mac_control;
@@ -2320,12 +2319,15 @@
DBG_PRINT(INTR_DBG, "%s: Next block at: %p\n",
dev->name, rxdp);
}
-#ifndef CONFIG_S2IO_NAPI
- spin_lock_irqsave(&nic->put_lock, flags);
- mac_control->rings[ring_no].put_pos =
- (block_no * (rxd_count[nic->rxd_mode] + 1)) + off;
- spin_unlock_irqrestore(&nic->put_lock, flags);
-#endif
+ if(!napi) {
+ spin_lock_irqsave(&nic->put_lock, flags);
+ mac_control->rings[ring_no].put_pos =
+ (block_no * (rxd_count[nic->rxd_mode] + 1)) + off;
+ spin_unlock_irqrestore(&nic->put_lock, flags);
+ } else {
+ mac_control->rings[ring_no].put_pos =
+ (block_no * (rxd_count[nic->rxd_mode] + 1)) + off;
+ }
if ((rxdp->Control_1 & RXD_OWN_XENA) &&
((nic->rxd_mode >= RXD_MODE_3A) &&
(rxdp->Control_2 & BIT(0)))) {
@@ -2568,7 +2570,6 @@
* 0 on success and 1 if there are No Rx packets to be processed.
*/
-#if defined(CONFIG_S2IO_NAPI)
static int s2io_poll(struct net_device *dev, int *budget)
{
nic_t *nic = dev->priv;
@@ -2633,7 +2634,6 @@
atomic_dec(&nic->isr_cnt);
return 1;
}
-#endif
#ifdef CONFIG_NET_POLL_CONTROLLER
/**
@@ -2707,9 +2707,7 @@
rx_curr_get_info_t get_info, put_info;
RxD_t *rxdp;
struct sk_buff *skb;
-#ifndef CONFIG_S2IO_NAPI
int pkt_cnt = 0;
-#endif
int i;
spin_lock(&nic->rx_lock);
@@ -2725,16 +2723,18 @@
put_info = ring_data->rx_curr_put_info;
put_block = put_info.block_index;
rxdp = ring_data->rx_blocks[get_block].rxds[get_info.offset].virt_addr;
-#ifndef CONFIG_S2IO_NAPI
- spin_lock(&nic->put_lock);
- put_offset = ring_data->put_pos;
- spin_unlock(&nic->put_lock);
-#else
- put_offset = (put_block * (rxd_count[nic->rxd_mode] + 1)) +
- put_info.offset;
-#endif
+ if (!napi) {
+ spin_lock(&nic->put_lock);
+ put_offset = ring_data->put_pos;
+ spin_unlock(&nic->put_lock);
+ } else
+ put_offset = ring_data->put_pos;
+
while (RXD_IS_UP2DT(rxdp)) {
- /* If your are next to put index then it's FIFO full condition */
+ /*
+ * If your are next to put index then it's
+ * FIFO full condition
+ */
if ((get_block == put_block) &&
(get_info.offset + 1) == put_info.offset) {
DBG_PRINT(INTR_DBG, "%s: Ring Full\n",dev->name);
@@ -2792,15 +2792,12 @@
rxdp = ring_data->rx_blocks[get_block].block_virt_addr;
}
-#ifdef CONFIG_S2IO_NAPI
nic->pkts_to_process -= 1;
- if (!nic->pkts_to_process)
+ if ((napi) && (!nic->pkts_to_process))
break;
-#else
pkt_cnt++;
if ((indicate_max_pkts) && (pkt_cnt > indicate_max_pkts))
break;
-#endif
}
if (nic->lro) {
/* Clear all LRO sessions before exiting */
@@ -4193,26 +4190,26 @@
org_mask = readq(&bar0->general_int_mask);
writeq(val64, &bar0->general_int_mask);
-#ifdef CONFIG_S2IO_NAPI
- if (reason & GEN_INTR_RXTRAFFIC) {
- if (netif_rx_schedule_prep(dev)) {
- writeq(val64, &bar0->rx_traffic_mask);
- __netif_rx_schedule(dev);
+ if (napi) {
+ if (reason & GEN_INTR_RXTRAFFIC) {
+ if (netif_rx_schedule_prep(dev)) {
+ writeq(val64, &bar0->rx_traffic_mask);
+ __netif_rx_schedule(dev);
+ }
+ }
+ } else {
+ /*
+ * Rx handler is called by default, without checking for the
+ * cause of interrupt.
+ * rx_traffic_int reg is an R1 register, writing all 1's
+ * will ensure that the actual interrupt causing bit get's
+ * cleared and hence a read can be avoided.
+ */
+ writeq(val64, &bar0->rx_traffic_int);
+ for (i = 0; i < config->rx_ring_num; i++) {
+ rx_intr_handler(&mac_control->rings[i]);
}
}
-#else
- /*
- * Rx handler is called by default, without checking for the
- * cause of interrupt.
- * rx_traffic_int reg is an R1 register, writing all 1's
- * will ensure that the actual interrupt causing bit get's
- * cleared and hence a read can be avoided.
- */
- writeq(val64, &bar0->rx_traffic_int);
- for (i = 0; i < config->rx_ring_num; i++) {
- rx_intr_handler(&mac_control->rings[i]);
- }
-#endif
/*
* tx_traffic_int reg is an R1 register, writing all 1's
@@ -4231,11 +4228,14 @@
* reallocate the buffers from the interrupt handler itself,
* else schedule a tasklet to reallocate the buffers.
*/
-#ifndef CONFIG_S2IO_NAPI
- for (i = 0; i < config->rx_ring_num; i++)
- s2io_chk_rx_buffers(sp, i);
-#endif
- writeq(org_mask, &bar0->general_int_mask);
+ if (!napi) {
+ for (i = 0; i < config->rx_ring_num; i++)
+ s2io_chk_rx_buffers(sp, i);
+ }
+
+ writeq(0, &bar0->general_int_mask);
+ readl(&bar0->general_int_status);
+
atomic_dec(&sp->isr_cnt);
return IRQ_HANDLED;
}
@@ -6578,23 +6578,20 @@
if (!sp->lro) {
skb->protocol = eth_type_trans(skb, dev);
-#ifdef CONFIG_S2IO_NAPI
if (sp->vlgrp && RXD_GET_VLAN_TAG(rxdp->Control_2)) {
/* Queueing the vlan frame to the upper layer */
- vlan_hwaccel_receive_skb(skb, sp->vlgrp,
- RXD_GET_VLAN_TAG(rxdp->Control_2));
+ if (napi)
+ vlan_hwaccel_receive_skb(skb, sp->vlgrp,
+ RXD_GET_VLAN_TAG(rxdp->Control_2));
+ else
+ vlan_hwaccel_rx(skb, sp->vlgrp,
+ RXD_GET_VLAN_TAG(rxdp->Control_2));
} else {
- netif_receive_skb(skb);
+ if (napi)
+ netif_receive_skb(skb);
+ else
+ netif_rx(skb);
}
-#else
- if (sp->vlgrp && RXD_GET_VLAN_TAG(rxdp->Control_2)) {
- /* Queueing the vlan frame to the upper layer */
- vlan_hwaccel_rx(skb, sp->vlgrp,
- RXD_GET_VLAN_TAG(rxdp->Control_2));
- } else {
- netif_rx(skb);
- }
-#endif
} else {
send_up:
queue_rx_frame(skb);
@@ -6695,13 +6692,9 @@
DBG_PRINT(ERR_DBG, "s2io: Default to 8 Rx rings\n");
rx_ring_num = 8;
}
-#ifdef CONFIG_S2IO_NAPI
- if (*dev_intr_type != INTA) {
- DBG_PRINT(ERR_DBG, "s2io: NAPI cannot be enabled when "
- "MSI/MSI-X is enabled. Defaulting to INTA\n");
- *dev_intr_type = INTA;
- }
-#endif
+ if (*dev_intr_type != INTA)
+ napi = 0;
+
#ifndef CONFIG_PCI_MSI
if (*dev_intr_type != INTA) {
DBG_PRINT(ERR_DBG, "s2io: This kernel does not support"
@@ -6962,10 +6955,8 @@
* will use eth_mac_addr() for dev->set_mac_address
* mac address will be set every time dev->open() is called
*/
-#if defined(CONFIG_S2IO_NAPI)
dev->poll = s2io_poll;
dev->weight = 32;
-#endif
#ifdef CONFIG_NET_POLL_CONTROLLER
dev->poll_controller = s2io_netpoll;
@@ -6976,7 +6967,7 @@
dev->features |= NETIF_F_HIGHDMA;
dev->features |= NETIF_F_TSO;
dev->features |= NETIF_F_TSO6;
- if (sp->device_type & XFRAME_II_DEVICE) {
+ if ((sp->device_type & XFRAME_II_DEVICE) && (ufo)) {
dev->features |= NETIF_F_UFO;
dev->features |= NETIF_F_HW_CSUM;
}
@@ -7057,9 +7048,9 @@
/* Initialize spinlocks */
spin_lock_init(&sp->tx_lock);
-#ifndef CONFIG_S2IO_NAPI
- spin_lock_init(&sp->put_lock);
-#endif
+
+ if (!napi)
+ spin_lock_init(&sp->put_lock);
spin_lock_init(&sp->rx_lock);
/*
@@ -7120,9 +7111,9 @@
dev->name);
break;
}
-#ifdef CONFIG_S2IO_NAPI
- DBG_PRINT(ERR_DBG, "%s: NAPI enabled\n", dev->name);
-#endif
+
+ if (napi)
+ DBG_PRINT(ERR_DBG, "%s: NAPI enabled\n", dev->name);
switch(sp->intr_type) {
case INTA:
DBG_PRINT(ERR_DBG, "%s: Interrupt type INTA\n", dev->name);
@@ -7137,7 +7128,9 @@
if (sp->lro)
DBG_PRINT(ERR_DBG, "%s: Large receive offload enabled\n",
dev->name);
-
+ if (ufo)
+ DBG_PRINT(ERR_DBG, "%s: UDP Fragmentation Offload(UFO)"
+ " enabled\n", dev->name);
/* Initialize device name */
sprintf(sp->name, "%s Neterion %s", dev->name, sp->product_name);
@@ -7539,11 +7532,10 @@
struct net_device *dev = skb->dev;
skb->protocol = eth_type_trans(skb, dev);
-#ifdef CONFIG_S2IO_NAPI
- netif_receive_skb(skb);
-#else
- netif_rx(skb);
-#endif
+ if (napi)
+ netif_receive_skb(skb);
+ else
+ netif_rx(skb);
}
static void lro_append_pkt(nic_t *sp, lro_t *lro, struct sk_buff *skb,