i2c: rcar: fix MNR interrupt handling
Sometimes the MNR and MST interrupts happen simultaneously (stop automatically
follows NACK, according to the manuals) and in such case the ID_NACK flag isn't
set since the MST interrupt handling precedes MNR and all interrupts are cleared
and disabled then, so that MNR interrupt is never noticed -- this causes NACK'ed
transfers to be falsely reported as successful. Exchanging MNR and MST handlers
fixes this issue, however the MNR bit somehow gets set again even after being
explicitly cleared, so I decided to completely suppress handling of all disabled
interrupts (which is a good thing anyway)...
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Cc: stable@vger.kernel.org
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/drivers/i2c/busses/i2c-rcar.c b/drivers/i2c/busses/i2c-rcar.c
index f3c7139..dc32f5fa 100644
--- a/drivers/i2c/busses/i2c-rcar.c
+++ b/drivers/i2c/busses/i2c-rcar.c
@@ -367,18 +367,15 @@
msr = rcar_i2c_read(priv, ICMSR);
+ /* Only handle interrupts that are currently enabled */
+ msr &= rcar_i2c_read(priv, ICMIER);
+
/* Arbitration lost */
if (msr & MAL) {
rcar_i2c_flags_set(priv, (ID_DONE | ID_ARBLOST));
goto out;
}
- /* Stop */
- if (msr & MST) {
- rcar_i2c_flags_set(priv, ID_DONE);
- goto out;
- }
-
/* Nack */
if (msr & MNR) {
/* go to stop phase */
@@ -388,6 +385,12 @@
goto out;
}
+ /* Stop */
+ if (msr & MST) {
+ rcar_i2c_flags_set(priv, ID_DONE);
+ goto out;
+ }
+
if (rcar_i2c_is_recv(priv))
rcar_i2c_flags_set(priv, rcar_i2c_irq_recv(priv, msr));
else