firmware: qcom: scm: Expose PAS command 10 as reset-controller
PAS command 10 is used to assert and deassert the MSS reset via
TrustZone, expose this as a reset-controller to mimic the direct
access case.
Cc: Stephen Boyd <sboyd@codeaurora.org>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Acked-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Stephen Boyd <sboyd@codeaurora.org>
Signed-off-by: Andy Gross <andy.gross@linaro.org>
diff --git a/drivers/firmware/qcom_scm-64.c b/drivers/firmware/qcom_scm-64.c
index 3ac2490..4a0f5ea 100644
--- a/drivers/firmware/qcom_scm-64.c
+++ b/drivers/firmware/qcom_scm-64.c
@@ -342,3 +342,19 @@
return ret ? : res.a1;
}
+
+int __qcom_scm_pas_mss_reset(struct device *dev, bool reset)
+{
+ struct qcom_scm_desc desc = {0};
+ struct arm_smccc_res res;
+ int ret;
+
+ desc.args[0] = reset;
+ desc.args[1] = 0;
+ desc.arginfo = QCOM_SCM_ARGS(2);
+
+ ret = qcom_scm_call(dev, QCOM_SCM_SVC_PIL, QCOM_SCM_PAS_MSS_RESET, &desc,
+ &res);
+
+ return ret ? : res.a1;
+}