tty/serial: digicolor: Fix bad usage of IS_ERR_VALUE
IS_ERR_VALUE() assumes that its parameter is an unsigned long.
It can not be used to check if an unsigned int reflects an error.
Doing so can result in the following build warning.
drivers/tty/serial/digicolor-usart.c: In function ‘digicolor_uart_probe’:
include/linux/err.h:21:38: warning:
comparison is always false due to limited range of data type
drivers/tty/serial/digicolor-usart.c:485:6: note:
in expansion of macro ‘IS_ERR_VALUE’
If that warning is seen, an error return from platform_get_irq() is missed.
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Acked-by: Baruch Siach <baruch@tkos.co.il>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/digicolor-usart.c b/drivers/tty/serial/digicolor-usart.c
index a80cdad..02ad695 100644
--- a/drivers/tty/serial/digicolor-usart.c
+++ b/drivers/tty/serial/digicolor-usart.c
@@ -453,7 +453,7 @@
static int digicolor_uart_probe(struct platform_device *pdev)
{
struct device_node *np = pdev->dev.of_node;
- int ret, index;
+ int irq, ret, index;
struct digicolor_port *dp;
struct resource *res;
struct clk *uart_clk;
@@ -481,9 +481,10 @@
if (IS_ERR(dp->port.membase))
return PTR_ERR(dp->port.membase);
- dp->port.irq = platform_get_irq(pdev, 0);
- if (IS_ERR_VALUE(dp->port.irq))
- return dp->port.irq;
+ irq = platform_get_irq(pdev, 0);
+ if (irq < 0)
+ return irq;
+ dp->port.irq = irq;
dp->port.iotype = UPIO_MEM;
dp->port.uartclk = clk_get_rate(uart_clk);