Merge "ARM: dts: msm: use short name for memdump nodes on SDM670"
diff --git a/drivers/soc/qcom/Kconfig b/drivers/soc/qcom/Kconfig
index 18aaacc..9750969 100644
--- a/drivers/soc/qcom/Kconfig
+++ b/drivers/soc/qcom/Kconfig
@@ -251,6 +251,23 @@
of deadlocks or cpu hangs these dump regions are captured to
give a snapshot of the system at the time of the crash.
+config QCOM_MINIDUMP
+ bool "QCOM Minidump Support"
+ depends on MSM_SMEM && QCOM_DLOAD_MODE
+ help
+ This enables minidump feature. It allows various clients to
+ register to dump their state at system bad state (panic/WDT,etc.,).
+ Minidump would dump all registered entries, only when DLOAD mode
+ is enabled.
+
+config MINIDUMP_MAX_ENTRIES
+ int "Minidump Maximum num of entries"
+ default 200
+ depends on QCOM_MINIDUMP
+ help
+ This defines maximum number of entries to be allocated for application
+ subsytem in Minidump table.
+
config QCOM_BUS_SCALING
bool "Bus scaling driver"
help
@@ -693,4 +710,4 @@
help
The driver will help route diag traffic from modem side over the QDSS
sub-system to USB on APSS side. The driver acts as a bridge between the
- MHI and USB interface. If unsure, say N.
\ No newline at end of file
+ MHI and USB interface. If unsure, say N.