[SCSI] qla2xxx: Add Fibre Channel Event (FCE) tracing support.
FCE support enables the firmware to record FC extended link
services and basic link services frames which have been
transmitted and received by the ISP. This allows for a limited
view of the FC traffic through the ISP without using a FC
analyzer. This can be useful in situations where a physical
connection to the FC bus is not possible.
The driver exports this information in two ways -- first, via a
debugfs node exported for all supported ISPs under:
<debugfs_mount_point>/qla2xxx/qla2xxx_<host_no>/fce
where a read of the 'fce' file will provide a snapshot of the
firmware's FCE buffer; and finally, the FCE buffer will be
extracted during a firmware-dump scenario.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/qla2xxx/qla_def.h b/drivers/scsi/qla2xxx/qla_def.h
index 3f934bd..6f129da 100644
--- a/drivers/scsi/qla2xxx/qla_def.h
+++ b/drivers/scsi/qla2xxx/qla_def.h
@@ -2156,6 +2156,7 @@
uint32_t gpsc_supported :1;
uint32_t vsan_enabled :1;
uint32_t npiv_supported :1;
+ uint32_t fce_enabled :1;
} flags;
atomic_t loop_state;
@@ -2449,6 +2450,15 @@
dma_addr_t eft_dma;
void *eft;
+ struct dentry *dfs_dir;
+ struct dentry *dfs_fce;
+ dma_addr_t fce_dma;
+ void *fce;
+ uint32_t fce_bufs;
+ uint16_t fce_mb[8];
+ uint64_t fce_wr, fce_rd;
+ struct mutex fce_mutex;
+
uint8_t host_str[16];
uint32_t pci_attr;
uint16_t chip_revision;