blob: 7ef00642f48f8b47477d114f231e52bbc39ca5d7 [file] [log] [blame]
/*
* Copyright (c) 2017, 2020, The Linux Foundation. All rights reserved.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 and
* only version 2 as published by the Free Software Foundation.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*/
&msm_gpio {
BC847_pins {
pins = "gpio0";
qcom,num-grp-pins = <1>;
qcom,pin-func = <0>;
label = "BC847_pins";
BC847_default: en_default {
drive-strength = <2>;
bias-pull-down;
};
};
};
&soc {
flash_BC847:flashlight {
compatible = "qcom,leds-gpio-flash";
status = "okay";
pinctrl-names = "flash_default";
pinctrl-0 = <&BC847_default>;
qcom,flash-en = <&pm8909_gpios 4 0>;
qcom,flash-now = <&msm_gpio 0 0>;
qcom,op-seq = "flash_en", "flash_now";
qcom,torch-seq-val = <1 0>;
qcom,flash-seq-val = <1 0>;
linux,name = "flashlight";
linux,default-trigger = "flashlight-trigger";
};
led_flash0: qcom,camera-led-flash {
cell-index = <0>;
compatible = "qcom,camera-led-flash";
qcom,flash-type = <3>;
qcom,flash-source = <&flash_BC847>;
qcom,torch-source = <&flash_BC847>;
};
};
&i2c_3 {
actuator0: qcom,actuator@0 {
cell-index = <0>;
reg = <0x3>;
compatible = "qcom,actuator";
qcom,cci-master = <0>;
cam_vaf-supply = <&pm8909_l8>;
qcom,cam-vreg-name = "cam_vaf";
qcom,cam-vreg-type = <0>;
qcom,cam-vreg-min-voltage = <2850000>;
qcom,cam-vreg-max-voltage = <2900000>;
qcom,cam-vreg-op-mode = <80000>;
};
eeprom0: qcom,eeprom@6d{
cell-index = <0>;
reg = <0x6d>;
qcom,eeprom-name = "sunrise_pc0fe";
compatible = "qcom,eeprom";
qcom,slave-addr = <0x6d>;
qcom,cci-master = <0>;
qcom,num-blocks = <10>;
qcom,page0 = <1 0x0100 2 0x01 1 1>;
qcom,poll0 = <0 0x0 2 0 1 1>;
qcom,mem0 = <0 0x0 2 0 1 0>;
qcom,page1 = <1 0x5002 2 0xa8 1 1>;
qcom,poll1 = <0 0x0 2 0 1 1>;
qcom,mem1 = <0 0x0 2 0 1 0>;
qcom,page2 = <1 0x3d84 2 0xc0 1 1>;
qcom,poll2 = <0 0x0 2 0 1 1>;
qcom,mem2 = <0 0x0 2 0 1 0>;
qcom,page3 = <1 0x3d88 2 0x70 1 1>;
qcom,poll3 = <0 0x0 2 0 1 1>;
qcom,mem3 = <0 0x3d00 2 0 1 0>;
qcom,page4 = <1 0x3d89 2 0x10 1 1>;
qcom,poll4 = <0 0x0 2 0 1 1>;
qcom,mem4 = <0 0x3d00 2 0 1 0>;
qcom,page5 = <1 0x3d8a 2 0x70 1 1>;
qcom,poll5 = <0 0x0 2 0 1 1>;
qcom,mem5 = <0 0x3d00 2 0 1 0>;
qcom,page6 = <1 0x3d8b 2 0x29 1 1>;
qcom,poll6 = <0 0x0 2 0 1 1>;
qcom,mem6 = <0 0x3d00 2 0 1 0>;
qcom,page7 = <1 0x3d81 2 0x01 1 5>;
qcom,poll7 = <0 0x0 2 0 1 1>;
qcom,mem7 = <26 0x7010 2 0 1 1>;
qcom,page8 = <1 0x5002 2 0xaa 1 1>;
qcom,poll8 = <0 0x0 2 0 1 1>;
qcom,mem8 = <0 0x0 2 0 1 0>;
qcom,page9 = <1 0x0100 2 0x00 1 1>;
qcom,poll9 = <0 0x0 2 0 1 1>;
qcom,mem9 = <0 0x0 2 0 1 0>;
cam_vdig-supply = <&pm8909_l2>;
cam_vana-supply = <&pm8909_l17>;
cam_vio-supply = <&pm8909_l6>;
cam_vaf-supply = <&pm8909_l8>;
qcom,cam-vreg-name = "cam_vdig", "cam_vio", "cam_vana",
"cam_vaf";
qcom,cam-vreg-type = <0 1 0 0>;
qcom,cam-vreg-min-voltage = <1200000 0 2800000 2850000>;
qcom,cam-vreg-max-voltage = <1200000 0 2850000 2900000>;
qcom,cam-vreg-op-mode = <200000 0 80000 100000>;
pinctrl-names = "cam_default", "cam_suspend";
pinctrl-0 = <&cam_sensor_mclk0_default
&cam_sensor_rear_default>;
pinctrl-1 = <&cam_sensor_mclk0_sleep &cam_sensor_rear_sleep>;
gpios = <&msm_gpio 26 0>,
<&msm_gpio 35 0>,
<&msm_gpio 34 0>;
qcom,gpio-reset = <1>;
qcom,gpio-standby = <2>;
qcom,gpio-req-tbl-num = <0 1 2>;
qcom,gpio-req-tbl-flags = <1 0 0>;
qcom,gpio-req-tbl-label = "CAMIF_MCLK",
"CAM_RESET1",
"CAM_STANDBY";
qcom,cam-power-seq-type = "sensor_vreg",
"sensor_vreg", "sensor_vreg",
"sensor_gpio", "sensor_gpio",
"sensor_clk";
qcom,cam-power-seq-val = "cam_vio",
"cam_vana", "cam_vdig",
"sensor_gpio_reset",
"sensor_gpio_standby",
"sensor_cam_mclk" ;
qcom,cam-power-seq-cfg-val = <1 1 1 1 1 24000000>;
qcom,cam-power-seq-delay = <10 10 10 10 10 5>;
clocks = <&clock_gcc clk_mclk0_clk_src>,
<&clock_gcc clk_gcc_camss_mclk0_clk>;
clock-names = "cam_src_clk", "cam_clk";
};
qcom,camera@0 {
cell-index = <0>;
compatible = "qcom,camera";
reg = <0x2>;
qcom,special-support-sensors="ov5670_30010a3", "gc2365";
qcom,eeprom-src = <&eeprom0>;
qcom,csiphy-sd-index = <0>;
qcom,csid-sd-index = <0>;
qcom,mount-angle = <90>;
qcom,actuator-src = <&actuator0>;
qcom,led-flash-src = <&led_flash0>;
cam_vana-supply = <&pm8909_l17>;
cam_vio-supply = <&pm8909_l6>;
cam_vaf-supply = <&pm8909_l8>;
qcom,cam-vreg-name = "cam_vio", "cam_vana",
"cam_vaf";
qcom,cam-vreg-type = <1 0 0>;
qcom,cam-vreg-min-voltage = <0 2800000 2850000>;
qcom,cam-vreg-max-voltage = <0 2850000 2900000>;
qcom,cam-vreg-op-mode = <0 80000 100000>;
pinctrl-names = "cam_default", "cam_suspend";
pinctrl-0 = <&cam_sensor_mclk0_default
&cam_sensor_rear_default>;
pinctrl-1 = <&cam_sensor_mclk0_sleep &cam_sensor_rear_sleep>;
gpios = <&msm_gpio 26 0>,
<&msm_gpio 35 0>,
<&msm_gpio 34 0>;
qcom,gpio-reset = <1>;
qcom,gpio-standby = <2>;
qcom,gpio-req-tbl-num = <0 1 2>;
qcom,gpio-req-tbl-flags = <1 0 0>;
qcom,gpio-req-tbl-label = "CAMIF_MCLK",
"CAM_RESET1",
"CAM_STANDBY";
qcom,sensor-position = <0>;
qcom,sensor-mode = <0>;
qcom,cci-master = <0>;
status = "ok";
clocks = <&clock_gcc clk_mclk0_clk_src>,
<&clock_gcc clk_gcc_camss_mclk0_clk>;
clock-names = "cam_src_clk", "cam_clk";
};
qcom,camera@1 {
cell-index = <1>;
compatible = "qcom,camera";
reg = <0x1>;
qcom,special-support-sensors="ov2680_cht852b", "gc030a";
qcom,csiphy-sd-index = <0>;
qcom,csid-sd-index = <0>;
qcom,mount-angle = <90>;
cam_vana-supply = <&pm8909_l17>;
cam_vio-supply = <&pm8909_l6>;
qcom,cam-vreg-name = "cam_vio", "cam_vana";
qcom,cam-vreg-type = <1 0>;
qcom,cam-vreg-min-voltage = <0 2800000>;
qcom,cam-vreg-max-voltage = <0 2850000>;
qcom,cam-vreg-op-mode = <0 80000>;
pinctrl-names = "cam_default", "cam_suspend";
pinctrl-0 =
<&cam_sensor_mclk1_default &cam_sensor_front_default>;
pinctrl-1 = <&cam_sensor_mclk1_sleep &cam_sensor_front_sleep>;
gpios = <&msm_gpio 27 0>,
<&msm_gpio 28 0>,
<&msm_gpio 33 0>;
qcom,gpio-reset = <1>;
qcom,gpio-standby = <2>;
qcom,gpio-req-tbl-num = <0 1 2>;
qcom,gpio-req-tbl-flags = <1 0 0>;
qcom,gpio-req-tbl-label = "CAMIF_MCLK",
"CAM_RESET",
"CAM_STANDBY";
qcom,cci-master = <0>;
status = "ok";
clocks = <&clock_gcc clk_mclk1_clk_src>,
<&clock_gcc clk_gcc_camss_mclk1_clk>;
clock-names = "cam_src_clk", "cam_clk";
};
};