mmc: MMC 4.4 DDR support
Add support for Dual Data Rate MMC cards as defined in the 4.4
specification.
Signed-off-by: Hanumath Prasad <hanumath.prasad@stericsson.com>
Cc: linux-mmc@vger.kernel.org
Acked-by: Linus Walleij <linus.walleij@stericsson.com>
Tested-by Zhangfei Gao <zhangfei.gao@marvell.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/include/linux/mmc/card.h b/include/linux/mmc/card.h
index 7bd4923..8ce0827 100644
--- a/include/linux/mmc/card.h
+++ b/include/linux/mmc/card.h
@@ -48,6 +48,7 @@
unsigned int sa_timeout; /* Units: 100ns */
unsigned int hs_max_dtr;
unsigned int sectors;
+ unsigned int card_type;
unsigned int hc_erase_size; /* In sectors */
unsigned int hc_erase_timeout; /* In milliseconds */
unsigned int sec_trim_mult; /* Secure trim multiplier */
@@ -113,6 +114,7 @@
#define MMC_STATE_READONLY (1<<1) /* card is read-only */
#define MMC_STATE_HIGHSPEED (1<<2) /* card is in high speed mode */
#define MMC_STATE_BLOCKADDR (1<<3) /* card uses block-addressing */
+#define MMC_STATE_HIGHSPEED_DDR (1<<4) /* card is in high speed mode */
unsigned int quirks; /* card quirks */
#define MMC_QUIRK_LENIENT_FN0 (1<<0) /* allow SDIO FN0 writes outside of the VS CCCR range */
#define MMC_QUIRK_BLKSZ_FOR_BYTE_MODE (1<<1) /* use func->cur_blksize */
@@ -154,11 +156,13 @@
#define mmc_card_readonly(c) ((c)->state & MMC_STATE_READONLY)
#define mmc_card_highspeed(c) ((c)->state & MMC_STATE_HIGHSPEED)
#define mmc_card_blockaddr(c) ((c)->state & MMC_STATE_BLOCKADDR)
+#define mmc_card_ddr_mode(c) ((c)->state & MMC_STATE_HIGHSPEED_DDR)
#define mmc_card_set_present(c) ((c)->state |= MMC_STATE_PRESENT)
#define mmc_card_set_readonly(c) ((c)->state |= MMC_STATE_READONLY)
#define mmc_card_set_highspeed(c) ((c)->state |= MMC_STATE_HIGHSPEED)
#define mmc_card_set_blockaddr(c) ((c)->state |= MMC_STATE_BLOCKADDR)
+#define mmc_card_set_ddr_mode(c) ((c)->state |= MMC_STATE_HIGHSPEED_DDR)
static inline int mmc_card_lenient_fn0(const struct mmc_card *c)
{