ide: change ->set_pio_mode method parameters
Change ->set_pio_mode method parameters to match ->set_piomode method
used in struct ata_port_operations.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/ide/scc_pata.c b/drivers/ide/scc_pata.c
index 1104bb3..23e16e4 100644
--- a/drivers/ide/scc_pata.c
+++ b/drivers/ide/scc_pata.c
@@ -199,16 +199,15 @@
/**
* scc_set_pio_mode - set host controller for PIO mode
+ * @hwif: port
* @drive: drive
- * @pio: PIO mode number
*
* Load the timing settings for this device mode into the
* controller.
*/
-static void scc_set_pio_mode(ide_drive_t *drive, const u8 pio)
+static void scc_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)
{
- ide_hwif_t *hwif = drive->hwif;
struct scc_ports *ports = ide_get_hwifdata(hwif);
unsigned long ctl_base = ports->ctl;
unsigned long cckctrl_port = ctl_base + 0xff0;
@@ -216,6 +215,7 @@
unsigned long pioct_port = ctl_base + 0x004;
unsigned long reg;
int offset;
+ const u8 pio = drive->pio_mode - XFER_PIO_0;
reg = in_be32((void __iomem *)cckctrl_port);
if (reg & CCKCTRL_ATACLKOEN) {