ACPI 5.0: Support for all new resource descriptors
FixedDMA, GPIO descriptors, SerialBus descriptors
Signed-off-by: Lin Ming <ming.m.lin@intel.com>
Signed-off-by: Bob Moore <robert.moore@intel.com>
Signed-off-by: Len Brown <len.brown@intel.com>
diff --git a/include/acpi/acrestyp.h b/include/acpi/acrestyp.h
index 0a66cc4..3506e39 100644
--- a/include/acpi/acrestyp.h
+++ b/include/acpi/acrestyp.h
@@ -61,11 +61,14 @@
#define ACPI_WRITE_COMBINING_MEMORY (u8) 0x02
#define ACPI_PREFETCHABLE_MEMORY (u8) 0x03
+/*! [Begin] no source code translation */
/*
* IO Attributes
- * The ISA IO ranges are: n000-n0_fFh, n400-n4_fFh, n800-n8_fFh, n_c00-n_cFFh.
- * The non-ISA IO ranges are: n100-n3_fFh, n500-n7_fFh, n900-n_bFFh, n_cd0-n_fFFh.
+ * The ISA IO ranges are: n000-n0FFh, n400-n4FFh, n800-n8FFh, nC00-nCFFh.
+ * The non-ISA IO ranges are: n100-n3FFh, n500-n7FFh, n900-nBFFh, nCD0-nFFFh.
*/
+/*! [End] no source code translation !*/
+
#define ACPI_NON_ISA_ONLY_RANGES (u8) 0x01
#define ACPI_ISA_ONLY_RANGES (u8) 0x02
#define ACPI_ENTIRE_RANGE (ACPI_NON_ISA_ONLY_RANGES | ACPI_ISA_ONLY_RANGES)
@@ -81,16 +84,26 @@
#define ACPI_DECODE_16 (u8) 0x01 /* 16-bit IO address decode */
/*
- * IRQ Attributes
+ * Interrupt attributes - used in multiple descriptors
*/
+
+/* Triggering */
+
#define ACPI_LEVEL_SENSITIVE (u8) 0x00
#define ACPI_EDGE_SENSITIVE (u8) 0x01
+/* Polarity */
+
#define ACPI_ACTIVE_HIGH (u8) 0x00
#define ACPI_ACTIVE_LOW (u8) 0x01
+#define ACPI_ACTIVE_BOTH (u8) 0x02
+
+/* Sharing */
#define ACPI_EXCLUSIVE (u8) 0x00
#define ACPI_SHARED (u8) 0x01
+#define ACPI_EXCLUSIVE_AND_WAKE (u8) 0x02
+#define ACPI_SHARED_AND_WAKE (u8) 0x03
/*
* DMA Attributes
@@ -127,6 +140,8 @@
#define ACPI_POS_DECODE (u8) 0x00
#define ACPI_SUB_DECODE (u8) 0x01
+/* Producer/Consumer */
+
#define ACPI_PRODUCER (u8) 0x00
#define ACPI_CONSUMER (u8) 0x01
@@ -192,6 +207,21 @@
u8 address_length;
};
+struct acpi_resource_fixed_dma {
+ u16 request_lines;
+ u16 channels;
+ u8 width;
+};
+
+/* Values for Width field above */
+
+#define ACPI_DMA_WIDTH8 0
+#define ACPI_DMA_WIDTH16 1
+#define ACPI_DMA_WIDTH32 2
+#define ACPI_DMA_WIDTH64 3
+#define ACPI_DMA_WIDTH128 4
+#define ACPI_DMA_WIDTH256 5
+
struct acpi_resource_vendor {
u16 byte_length;
u8 byte_data[1];
@@ -329,6 +359,166 @@
u64 address;
};
+struct acpi_resource_gpio {
+ u8 revision_id;
+ u8 connection_type;
+ u8 producer_consumer; /* For values, see Producer/Consumer above */
+ u8 pin_config;
+ u8 sharable; /* For values, see Interrupt Attributes above */
+ u8 io_restriction;
+ u8 triggering; /* For values, see Interrupt Attributes above */
+ u8 polarity; /* For values, see Interrupt Attributes above */
+ u16 drive_strength;
+ u16 debounce_timeout;
+ u16 pin_table_length;
+ u16 vendor_length;
+ struct acpi_resource_source resource_source;
+ u16 *pin_table;
+ u8 *vendor_data;
+};
+
+/* Values for GPIO connection_type field above */
+
+#define ACPI_RESOURCE_GPIO_TYPE_INT 0
+#define ACPI_RESOURCE_GPIO_TYPE_IO 1
+
+/* Values for pin_config field above */
+
+#define ACPI_PIN_CONFIG_DEFAULT 0
+#define ACPI_PIN_CONFIG_PULLUP 1
+#define ACPI_PIN_CONFIG_PULLDOWN 2
+#define ACPI_PIN_CONFIG_NOPULL 3
+
+/* Values for io_restriction field above */
+
+#define ACPI_IO_RESTRICT_NONE 0
+#define ACPI_IO_RESTRICT_INPUT 1
+#define ACPI_IO_RESTRICT_OUTPUT 2
+#define ACPI_IO_RESTRICT_NONE_PRESERVE 3
+
+/* Common structure for I2C, SPI, and UART serial descriptors */
+
+#define ACPI_RESOURCE_SERIAL_COMMON \
+ u8 revision_id; \
+ u8 type; \
+ u8 producer_consumer; /* For values, see Producer/Consumer above */\
+ u8 slave_mode; \
+ u8 type_revision_id; \
+ u16 type_data_length; \
+ u16 vendor_length; \
+ struct acpi_resource_source resource_source; \
+ u8 *vendor_data;
+
+struct acpi_resource_common_serialbus {
+ACPI_RESOURCE_SERIAL_COMMON};
+
+/* Values for the Type field above */
+
+#define ACPI_RESOURCE_SERIAL_TYPE_I2C 1
+#define ACPI_RESOURCE_SERIAL_TYPE_SPI 2
+#define ACPI_RESOURCE_SERIAL_TYPE_UART 3
+
+/* Values for slave_mode field above */
+
+#define ACPI_CONTROLLER_INITIATED 0
+#define ACPI_DEVICE_INITIATED 1
+
+struct acpi_resource_i2c_serialbus {
+ ACPI_RESOURCE_SERIAL_COMMON u8 access_mode;
+ u16 slave_address;
+ u32 connection_speed;
+};
+
+/* Values for access_mode field above */
+
+#define ACPI_I2C_7BIT_MODE 0
+#define ACPI_I2C_10BIT_MODE 1
+
+struct acpi_resource_spi_serialbus {
+ ACPI_RESOURCE_SERIAL_COMMON u8 wire_mode;
+ u8 device_polarity;
+ u8 data_bit_length;
+ u8 clock_phase;
+ u8 clock_polarity;
+ u16 device_selection;
+ u32 connection_speed;
+};
+
+/* Values for wire_mode field above */
+
+#define ACPI_SPI_4WIRE_MODE 0
+#define ACPI_SPI_3WIRE_MODE 1
+
+/* Values for device_polarity field above */
+
+#define ACPI_SPI_ACTIVE_LOW 0
+#define ACPI_SPI_ACTIVE_HIGH 1
+
+/* Values for clock_phase field above */
+
+#define ACPI_SPI_FIRST_PHASE 0
+#define ACPI_SPI_SECOND_PHASE 1
+
+/* Values for clock_polarity field above */
+
+#define ACPI_SPI_START_LOW 0
+#define ACPI_SPI_START_HIGH 1
+
+struct acpi_resource_uart_serialbus {
+ ACPI_RESOURCE_SERIAL_COMMON u8 endian;
+ u8 data_bits;
+ u8 stop_bits;
+ u8 flow_control;
+ u8 parity;
+ u8 lines_enabled;
+ u16 rx_fifo_size;
+ u16 tx_fifo_size;
+ u32 default_baud_rate;
+};
+
+/* Values for Endian field above */
+
+#define ACPI_UART_LITTLE_ENDIAN 0
+#define ACPI_UART_BIG_ENDIAN 1
+
+/* Values for data_bits field above */
+
+#define ACPI_UART_5_DATA_BITS 0
+#define ACPI_UART_6_DATA_BITS 1
+#define ACPI_UART_7_DATA_BITS 2
+#define ACPI_UART_8_DATA_BITS 3
+#define ACPI_UART_9_DATA_BITS 4
+
+/* Values for stop_bits field above */
+
+#define ACPI_UART_NO_STOP_BITS 0
+#define ACPI_UART_1_STOP_BIT 1
+#define ACPI_UART_1P5_STOP_BITS 2
+#define ACPI_UART_2_STOP_BITS 3
+
+/* Values for flow_control field above */
+
+#define ACPI_UART_FLOW_CONTROL_NONE 0
+#define ACPI_UART_FLOW_CONTROL_HW 1
+#define ACPI_UART_FLOW_CONTROL_XON_XOFF 2
+
+/* Values for Parity field above */
+
+#define ACPI_UART_PARITY_NONE 0
+#define ACPI_UART_PARITY_EVEN 1
+#define ACPI_UART_PARITY_ODD 2
+#define ACPI_UART_PARITY_MARK 3
+#define ACPI_UART_PARITY_SPACE 4
+
+/* Values for lines_enabled bitfield above */
+
+#define ACPI_UART_CARRIER_DETECT (1<<2)
+#define ACPI_UART_RING_INDICATOR (1<<3)
+#define ACPI_UART_DATA_SET_READY (1<<4)
+#define ACPI_UART_DATA_TERMINAL_READY (1<<5)
+#define ACPI_UART_CLEAR_TO_SEND (1<<6)
+#define ACPI_UART_REQUEST_TO_SEND (1<<7)
+
/* ACPI_RESOURCE_TYPEs */
#define ACPI_RESOURCE_TYPE_IRQ 0
@@ -348,7 +538,10 @@
#define ACPI_RESOURCE_TYPE_EXTENDED_ADDRESS64 14 /* ACPI 3.0 */
#define ACPI_RESOURCE_TYPE_EXTENDED_IRQ 15
#define ACPI_RESOURCE_TYPE_GENERIC_REGISTER 16
-#define ACPI_RESOURCE_TYPE_MAX 16
+#define ACPI_RESOURCE_TYPE_GPIO 17 /* ACPI 5.0 */
+#define ACPI_RESOURCE_TYPE_FIXED_DMA 18 /* ACPI 5.0 */
+#define ACPI_RESOURCE_TYPE_SERIAL_BUS 19 /* ACPI 5.0 */
+#define ACPI_RESOURCE_TYPE_MAX 19
/* Master union for resource descriptors */
@@ -358,6 +551,7 @@
struct acpi_resource_start_dependent start_dpf;
struct acpi_resource_io io;
struct acpi_resource_fixed_io fixed_io;
+ struct acpi_resource_fixed_dma fixed_dma;
struct acpi_resource_vendor vendor;
struct acpi_resource_vendor_typed vendor_typed;
struct acpi_resource_end_tag end_tag;
@@ -370,6 +564,11 @@
struct acpi_resource_extended_address64 ext_address64;
struct acpi_resource_extended_irq extended_irq;
struct acpi_resource_generic_register generic_reg;
+ struct acpi_resource_gpio gpio;
+ struct acpi_resource_i2c_serialbus i2c_serial_bus;
+ struct acpi_resource_spi_serialbus spi_serial_bus;
+ struct acpi_resource_uart_serialbus uart_serial_bus;
+ struct acpi_resource_common_serialbus common_serial_bus;
/* Common fields */