| config SND_OMAP_SOC |
| tristate "SoC Audio for the Texas Instruments OMAP chips" |
| depends on (ARCH_OMAP && DMA_OMAP) || (ARM && COMPILE_TEST) |
| select SND_DMAENGINE_PCM |
| |
| config SND_OMAP_SOC_DMIC |
| tristate |
| |
| config SND_OMAP_SOC_MCBSP |
| tristate |
| |
| config SND_OMAP_SOC_MCPDM |
| tristate |
| |
| config SND_OMAP_SOC_HDMI_AUDIO |
| tristate "HDMI audio support for OMAP4+ based SoCs" |
| depends on SND_OMAP_SOC |
| help |
| For HDMI audio to work OMAPDSS HDMI support should be |
| enabled. |
| The hdmi audio driver implements cpu-dai component using the |
| callbacks provided by OMAPDSS and registers the component |
| under DSS HDMI device. Omap-pcm is registered for platform |
| component also under DSS HDMI device. Dummy codec is used as |
| as codec component. The hdmi audio driver implements also |
| the card and registers it under its own platform device. |
| The device for the dirver is registered by OMAPDSS hdmi |
| driver. |
| |
| config SND_OMAP_SOC_N810 |
| tristate "SoC Audio support for Nokia N810" |
| depends on SND_OMAP_SOC && MACH_NOKIA_N810 && I2C |
| depends on OMAP_MUX |
| select SND_OMAP_SOC_MCBSP |
| select SND_SOC_TLV320AIC3X |
| help |
| Say Y if you want to add support for SoC audio on Nokia N810. |
| |
| config SND_OMAP_SOC_RX51 |
| tristate "SoC Audio support for Nokia N900 (RX-51)" |
| depends on SND_OMAP_SOC && ARM && I2C |
| select SND_OMAP_SOC_MCBSP |
| select SND_SOC_TLV320AIC3X |
| select SND_SOC_TPA6130A2 |
| depends on GPIOLIB |
| help |
| Say Y if you want to add support for SoC audio on Nokia N900 |
| cellphone. |
| |
| config SND_OMAP_SOC_AMS_DELTA |
| tristate "SoC Audio support for Amstrad E3 (Delta) videophone" |
| depends on SND_OMAP_SOC && MACH_AMS_DELTA && TTY |
| select SND_OMAP_SOC_MCBSP |
| select SND_SOC_CX20442 |
| help |
| Say Y if you want to add support for SoC audio device connected to |
| a handset and a speakerphone found on Amstrad E3 (Delta) videophone. |
| |
| Note that in order to get those devices fully supported, you have to |
| build the kernel with standard serial port driver included and |
| configured for at least 4 ports. Then, from userspace, you must load |
| a line discipline #19 on the modem (ttyS3) serial line. The simplest |
| way to achieve this is to install util-linux-ng and use the included |
| ldattach utility. This can be started automatically from udev, |
| a simple rule like this one should do the trick (it does for me): |
| ACTION=="add", KERNEL=="controlC0", \ |
| RUN+="/usr/sbin/ldattach 19 /dev/ttyS3" |
| |
| config SND_OMAP_SOC_OSK5912 |
| tristate "SoC Audio support for omap osk5912" |
| depends on SND_OMAP_SOC && MACH_OMAP_OSK && I2C |
| select SND_OMAP_SOC_MCBSP |
| select SND_SOC_TLV320AIC23_I2C |
| help |
| Say Y if you want to add support for SoC audio on osk5912. |
| |
| config SND_OMAP_SOC_AM3517EVM |
| tristate "SoC Audio support for OMAP3517 / AM3517 EVM" |
| depends on SND_OMAP_SOC && MACH_OMAP3517EVM && I2C |
| select SND_OMAP_SOC_MCBSP |
| select SND_SOC_TLV320AIC23_I2C |
| help |
| Say Y if you want to add support for SoC audio on the OMAP3517 / AM3517 |
| EVM. |
| |
| config SND_OMAP_SOC_OMAP_TWL4030 |
| tristate "SoC Audio support for TI SoC based boards with twl4030 codec" |
| depends on TWL4030_CORE && SND_OMAP_SOC |
| select SND_OMAP_SOC_MCBSP |
| select SND_SOC_TWL4030 |
| help |
| Say Y if you want to add support for SoC audio on TI SoC based boards |
| using twl4030 as c codec. This driver currently supports: |
| - Beagleboard or Devkit8000 |
| - Gumstix Overo or CompuLab CM-T35/CM-T3730 |
| - IGEP v2 |
| - OMAP3EVM |
| - SDP3430 |
| - Zoom2 |
| |
| config SND_OMAP_SOC_OMAP_ABE_TWL6040 |
| tristate "SoC Audio support for OMAP boards using ABE and twl6040 codec" |
| depends on TWL6040_CORE && SND_OMAP_SOC |
| depends on ARCH_OMAP4 || (SOC_OMAP5 && MFD_PALMAS) || COMPILE_TEST |
| select SND_OMAP_SOC_DMIC |
| select SND_OMAP_SOC_MCPDM |
| select SND_SOC_TWL6040 |
| select SND_SOC_DMIC |
| select COMMON_CLK_PALMAS if (SOC_OMAP5 && MFD_PALMAS) |
| help |
| Say Y if you want to add support for SoC audio on OMAP boards using |
| ABE and twl6040 codec. This driver currently supports: |
| - SDP4430/Blaze boards |
| - PandaBoard (4430) |
| - PandaBoardES (4460) |
| - omap5-uevm (5432) |
| |
| config SND_OMAP_SOC_OMAP3_PANDORA |
| tristate "SoC Audio support for OMAP3 Pandora" |
| depends on TWL4030_CORE && SND_OMAP_SOC && MACH_OMAP3_PANDORA |
| select SND_OMAP_SOC_MCBSP |
| select SND_SOC_TWL4030 |
| help |
| Say Y if you want to add support for SoC audio on the OMAP3 Pandora. |