[BNX2]: Fix VLAN on ASF
Always set up the device to strip incoming VLAN tags when ASF is
enabled. ASF firmware will not parse packets correctly if VLAN tags
are not stripped.
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index 49fa1e4..790dc92 100644
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -1916,11 +1916,11 @@
BNX2_EMAC_RX_MODE_KEEP_VLAN_TAG);
sort_mode = 1 | BNX2_RPM_SORT_USER0_BC_EN;
#ifdef BCM_VLAN
- if (!bp->vlgrp) {
+ if (!bp->vlgrp && !(bp->flags & ASF_ENABLE_FLAG))
rx_mode |= BNX2_EMAC_RX_MODE_KEEP_VLAN_TAG;
- }
#else
- rx_mode |= BNX2_EMAC_RX_MODE_KEEP_VLAN_TAG;
+ if (!(bp->flags & ASF_ENABLE_FLAG))
+ rx_mode |= BNX2_EMAC_RX_MODE_KEEP_VLAN_TAG;
#endif
if (dev->flags & IFF_PROMISC) {
/* Promiscuous mode. */
@@ -3218,6 +3218,10 @@
REG_WR(bp, BNX2_HC_ATTN_BITS_ENABLE, STATUS_ATTN_BITS_LINK_STATE);
+ if (REG_RD_IND(bp, bp->shmem_base + BNX2_PORT_FEATURE) &
+ BNX2_PORT_FEATURE_ASF_ENABLED)
+ bp->flags |= ASF_ENABLE_FLAG;
+
/* Initialize the receive filter. */
bnx2_set_rx_mode(bp->dev);