IB/ipath: Need to always request and handle PIO avail interrupts
Now that we always use PIO for vl15 on 7220, we could get stuck forever
if we happened to run out of PIO buffers from the verbs code, because
the setup code wouldn't run; the interrupt was also ignored if SDMA was
supported. We also have to reduce the pio update threshold if we have
fewer kernel buffers than the existing threshold.
Clean up the initialization a bit to get ordering safer and more
sensible, and use the existing ipath_chg_kernavail call to do init,
rather than doing it separately.
Drop unnecessary clearing of pio buffer on pio parity error.
Drop incorrect updating of pioavailshadow when exitting freeze mode
(software state may not match chip state if buffer has been allocated
and not yet written).
If we couldn't get a kernel buffer for a while, make sure we are
in sync with hardware, mainly to handle the exitting freeze case.
Signed-off-by: Dave Olson <dave.olson@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_driver.c b/drivers/infiniband/hw/ipath/ipath_driver.c
index f81dd4a..2036d38 100644
--- a/drivers/infiniband/hw/ipath/ipath_driver.c
+++ b/drivers/infiniband/hw/ipath/ipath_driver.c
@@ -1428,6 +1428,40 @@
spin_unlock_irqrestore(&ipath_pioavail_lock, flags);
}
+/*
+ * used to force update of pioavailshadow if we can't get a pio buffer.
+ * Needed primarily due to exitting freeze mode after recovering
+ * from errors. Done lazily, because it's safer (known to not
+ * be writing pio buffers).
+ */
+static void ipath_reset_availshadow(struct ipath_devdata *dd)
+{
+ int i, im;
+ unsigned long flags;
+
+ spin_lock_irqsave(&ipath_pioavail_lock, flags);
+ for (i = 0; i < dd->ipath_pioavregs; i++) {
+ u64 val, oldval;
+ /* deal with 6110 chip bug on high register #s */
+ im = (i > 3 && (dd->ipath_flags & IPATH_SWAP_PIOBUFS)) ?
+ i ^ 1 : i;
+ val = le64_to_cpu(dd->ipath_pioavailregs_dma[im]);
+ /*
+ * busy out the buffers not in the kernel avail list,
+ * without changing the generation bits.
+ */
+ oldval = dd->ipath_pioavailshadow[i];
+ dd->ipath_pioavailshadow[i] = val |
+ ((~dd->ipath_pioavailkernel[i] <<
+ INFINIPATH_SENDPIOAVAIL_BUSY_SHIFT) &
+ 0xaaaaaaaaaaaaaaaaULL); /* All BUSY bits in qword */
+ if (oldval != dd->ipath_pioavailshadow[i])
+ ipath_dbg("shadow[%d] was %Lx, now %lx\n",
+ i, oldval, dd->ipath_pioavailshadow[i]);
+ }
+ spin_unlock_irqrestore(&ipath_pioavail_lock, flags);
+}
+
/**
* ipath_setrcvhdrsize - set the receive header size
* @dd: the infinipath device
@@ -1482,9 +1516,12 @@
*/
ipath_stats.sps_nopiobufs++;
if (!(++dd->ipath_consec_nopiobuf % 100000)) {
- ipath_dbg("%u pio sends with no bufavail; dmacopy: "
- "%llx %llx %llx %llx; shadow: %lx %lx %lx %lx\n",
+ ipath_force_pio_avail_update(dd); /* at start */
+ ipath_dbg("%u tries no piobufavail ts%lx; dmacopy: "
+ "%llx %llx %llx %llx\n"
+ "ipath shadow: %lx %lx %lx %lx\n",
dd->ipath_consec_nopiobuf,
+ (unsigned long)get_cycles(),
(unsigned long long) le64_to_cpu(dma[0]),
(unsigned long long) le64_to_cpu(dma[1]),
(unsigned long long) le64_to_cpu(dma[2]),
@@ -1496,14 +1533,17 @@
*/
if ((dd->ipath_piobcnt2k + dd->ipath_piobcnt4k) >
(sizeof(shadow[0]) * 4 * 4))
- ipath_dbg("2nd group: dmacopy: %llx %llx "
- "%llx %llx; shadow: %lx %lx %lx %lx\n",
+ ipath_dbg("2nd group: dmacopy: "
+ "%llx %llx %llx %llx\n"
+ "ipath shadow: %lx %lx %lx %lx\n",
(unsigned long long)le64_to_cpu(dma[4]),
(unsigned long long)le64_to_cpu(dma[5]),
(unsigned long long)le64_to_cpu(dma[6]),
(unsigned long long)le64_to_cpu(dma[7]),
- shadow[4], shadow[5], shadow[6],
- shadow[7]);
+ shadow[4], shadow[5], shadow[6], shadow[7]);
+
+ /* at end, so update likely happened */
+ ipath_reset_availshadow(dd);
}
}
@@ -1652,19 +1692,46 @@
unsigned len, int avail)
{
unsigned long flags;
- unsigned end;
+ unsigned end, cnt = 0, next;
/* There are two bits per send buffer (busy and generation) */
start *= 2;
- len *= 2;
- end = start + len;
+ end = start + len * 2;
- /* Set or clear the generation bits. */
spin_lock_irqsave(&ipath_pioavail_lock, flags);
+ /* Set or clear the busy bit in the shadow. */
while (start < end) {
if (avail) {
- __clear_bit(start + INFINIPATH_SENDPIOAVAIL_BUSY_SHIFT,
- dd->ipath_pioavailshadow);
+ unsigned long dma;
+ int i, im;
+ /*
+ * the BUSY bit will never be set, because we disarm
+ * the user buffers before we hand them back to the
+ * kernel. We do have to make sure the generation
+ * bit is set correctly in shadow, since it could
+ * have changed many times while allocated to user.
+ * We can't use the bitmap functions on the full
+ * dma array because it is always little-endian, so
+ * we have to flip to host-order first.
+ * BITS_PER_LONG is slightly wrong, since it's
+ * always 64 bits per register in chip...
+ * We only work on 64 bit kernels, so that's OK.
+ */
+ /* deal with 6110 chip bug on high register #s */
+ i = start / BITS_PER_LONG;
+ im = (i > 3 && (dd->ipath_flags & IPATH_SWAP_PIOBUFS)) ?
+ i ^ 1 : i;
+ __clear_bit(INFINIPATH_SENDPIOAVAIL_BUSY_SHIFT
+ + start, dd->ipath_pioavailshadow);
+ dma = (unsigned long) le64_to_cpu(
+ dd->ipath_pioavailregs_dma[im]);
+ if (test_bit((INFINIPATH_SENDPIOAVAIL_CHECK_SHIFT
+ + start) % BITS_PER_LONG, &dma))
+ __set_bit(INFINIPATH_SENDPIOAVAIL_CHECK_SHIFT
+ + start, dd->ipath_pioavailshadow);
+ else
+ __clear_bit(INFINIPATH_SENDPIOAVAIL_CHECK_SHIFT
+ + start, dd->ipath_pioavailshadow);
__set_bit(start, dd->ipath_pioavailkernel);
} else {
__set_bit(start + INFINIPATH_SENDPIOAVAIL_BUSY_SHIFT,
@@ -1673,7 +1740,44 @@
}
start += 2;
}
+
+ if (dd->ipath_pioupd_thresh) {
+ end = 2 * (dd->ipath_piobcnt2k + dd->ipath_piobcnt4k);
+ next = find_first_bit(dd->ipath_pioavailkernel, end);
+ while (next < end) {
+ cnt++;
+ next = find_next_bit(dd->ipath_pioavailkernel, end,
+ next + 1);
+ }
+ }
spin_unlock_irqrestore(&ipath_pioavail_lock, flags);
+
+ /*
+ * When moving buffers from kernel to user, if number assigned to
+ * the user is less than the pio update threshold, and threshold
+ * is supported (cnt was computed > 0), drop the update threshold
+ * so we update at least once per allocated number of buffers.
+ * In any case, if the kernel buffers are less than the threshold,
+ * drop the threshold. We don't bother increasing it, having once
+ * decreased it, since it would typically just cycle back and forth.
+ * If we don't decrease below buffers in use, we can wait a long
+ * time for an update, until some other context uses PIO buffers.
+ */
+ if (!avail && len < cnt)
+ cnt = len;
+ if (cnt < dd->ipath_pioupd_thresh) {
+ dd->ipath_pioupd_thresh = cnt;
+ ipath_dbg("Decreased pio update threshold to %u\n",
+ dd->ipath_pioupd_thresh);
+ spin_lock_irqsave(&dd->ipath_sendctrl_lock, flags);
+ dd->ipath_sendctrl &= ~(INFINIPATH_S_UPDTHRESH_MASK
+ << INFINIPATH_S_UPDTHRESH_SHIFT);
+ dd->ipath_sendctrl |= dd->ipath_pioupd_thresh
+ << INFINIPATH_S_UPDTHRESH_SHIFT;
+ ipath_write_kreg(dd, dd->ipath_kregs->kr_sendctrl,
+ dd->ipath_sendctrl);
+ spin_unlock_irqrestore(&dd->ipath_sendctrl_lock, flags);
+ }
}
/**