[PATCH] pcmcia: use bitfield instead of p_state and state
Instead of the two status values struct pcmcia_device->p_state and state,
use descriptive bitfields. Most value-checking in drivers was invalid, as
the core now only calls the ->remove() (a.k.a. detach) function in case the
attachement _and_ configuration was successful.
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/usb/host/sl811_cs.c b/drivers/usb/host/sl811_cs.c
index e8b8e9a..302aa1e 100644
--- a/drivers/usb/host/sl811_cs.c
+++ b/drivers/usb/host/sl811_cs.c
@@ -142,9 +142,7 @@
{
DBG(0, "sl811_cs_detach(0x%p)\n", link);
- link->state &= ~DEV_PRESENT;
- if (link->state & DEV_CONFIG)
- sl811_cs_release(link);
+ sl811_cs_release(link);
/* This points to the parent local_info_t struct */
kfree(link->priv);
@@ -182,9 +180,6 @@
link->conf.ConfigBase = parse.config.base;
link->conf.Present = parse.config.rmask[0];
- /* Configure card */
- link->state |= DEV_CONFIG;
-
/* Look up the current Vcc */
CS_CHECK(GetConfigurationInfo,
pcmcia_get_configuration_info(link, &conf));
@@ -276,15 +271,12 @@
link->io.BasePort1+link->io.NumPorts1-1);
printk("\n");
- link->state &= ~DEV_CONFIG_PENDING;
-
if (sl811_hc_init(parent, link->io.BasePort1, link->irq.AssignedIRQ)
< 0) {
cs_failed:
printk("sl811_cs_config failed\n");
cs_error(link, last_fn, last_ret);
sl811_cs_release(link);
- link->state &= ~DEV_CONFIG_PENDING;
return -ENODEV;
}
return 0;
@@ -309,7 +301,6 @@
link->conf.Attributes = 0;
link->conf.IntType = INT_MEMORY_AND_IO;
- link->state |= DEV_PRESENT | DEV_CONFIG_PENDING;
return sl811_cs_config(link);
}