ath9k: Simplify ANI initialization
The check "enable_ani" is not required since it is always
set to true and the logic for disabling/enabling ANI via
debugfs is done at a higher layer.
Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/htc_drv_main.c b/drivers/net/wireless/ath/ath9k/htc_drv_main.c
index 2a67b57..34869c2 100644
--- a/drivers/net/wireless/ath/ath9k/htc_drv_main.c
+++ b/drivers/net/wireless/ath/ath9k/htc_drv_main.c
@@ -814,8 +814,7 @@
}
/* Verify whether we must check ANI */
- if (ah->config.enable_ani &&
- (timestamp - common->ani.checkani_timer) >= ATH_ANI_POLLINTERVAL) {
+ if ((timestamp - common->ani.checkani_timer) >= ATH_ANI_POLLINTERVAL) {
aniflag = true;
common->ani.checkani_timer = timestamp;
}
@@ -845,8 +844,7 @@
* short calibration and long calibration.
*/
cal_interval = ATH_LONG_CALINTERVAL;
- if (ah->config.enable_ani)
- cal_interval = min(cal_interval, (u32)ATH_ANI_POLLINTERVAL);
+ cal_interval = min(cal_interval, (u32)ATH_ANI_POLLINTERVAL);
if (!common->ani.caldone)
cal_interval = min(cal_interval, (u32)short_cal_interval);