net/mlx4_en: Add support for hardware accelerated 802.1ad vlan
To enable device support in accelerated 802.1ad vlan, the port
capability "packet has vlan enable" (phv_en) should be set.
Firmware won't work properly, in case phv_en is not set.
The user can enable "phv_en" port capability with the new ethtool
private flag phv-bit. The phv-bit private flag default value is OFF,
users who are interested in 802.1ad hardware acceleration should turn ON
the phv-bit private flag:
$ ethtool --set-priv-flags eth1 phv-bit on
Once the private flag is set, the device is ready for 802.1ad vlan
acceleration.
The user should also change the interface device features and turn on
"tx-vlan-stag-hw-insert" which is off by default:
$ ethtool -K eth1 tx-vlan-stag-hw-insert on
"phv-bit" private flag setting is available only for Physical
Functions(PF), the Virtual Function (VF) will be able to use the feature
by setting "tx-vlan-stag-hw-insert" ethtool device feature only if the
feature was enabled by the Hypervisor.
Signed-off-by: Hadar Hen Zion <hadarh@mellanox.com>
Signed-off-by: Amir Vadai <amirv@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/include/linux/mlx4/cq.h b/include/linux/mlx4/cq.h
index 899a97b..09cebe5 100644
--- a/include/linux/mlx4/cq.h
+++ b/include/linux/mlx4/cq.h
@@ -89,6 +89,7 @@
enum {
MLX4_CQE_L2_TUNNEL_IPOK = 1 << 31,
MLX4_CQE_CVLAN_PRESENT_MASK = 1 << 29,
+ MLX4_CQE_SVLAN_PRESENT_MASK = 1 << 30,
MLX4_CQE_L2_TUNNEL = 1 << 27,
MLX4_CQE_L2_TUNNEL_CSUM = 1 << 26,
MLX4_CQE_L2_TUNNEL_IPV4 = 1 << 25,