jme: convert driver to net_device_ops
Convert driver to new net_device_ops. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/jme.c b/drivers/net/jme.c
index 0430ffb..c387387 100644
--- a/drivers/net/jme.c
+++ b/drivers/net/jme.c
@@ -2625,6 +2625,18 @@
jme->chiprev = (chipmode & CM_CHIPREV_MASK) >> CM_CHIPREV_SHIFT;
}
+static const struct net_device_ops jme_netdev_ops = {
+ .ndo_open = jme_open,
+ .ndo_stop = jme_close,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_start_xmit = jme_start_xmit,
+ .ndo_set_mac_address = jme_set_macaddr,
+ .ndo_set_multicast_list = jme_set_multi,
+ .ndo_change_mtu = jme_change_mtu,
+ .ndo_tx_timeout = jme_tx_timeout,
+ .ndo_vlan_rx_register = jme_vlan_rx_register,
+};
+
static int __devinit
jme_init_one(struct pci_dev *pdev,
const struct pci_device_id *ent)
@@ -2674,17 +2686,9 @@
rc = -ENOMEM;
goto err_out_release_regions;
}
- netdev->open = jme_open;
- netdev->stop = jme_close;
- netdev->hard_start_xmit = jme_start_xmit;
- netdev->set_mac_address = jme_set_macaddr;
- netdev->set_multicast_list = jme_set_multi;
- netdev->change_mtu = jme_change_mtu;
+ netdev->netdev_ops = &jme_netdev_ops;
netdev->ethtool_ops = &jme_ethtool_ops;
- netdev->tx_timeout = jme_tx_timeout;
netdev->watchdog_timeo = TX_TIMEOUT;
- netdev->vlan_rx_register = jme_vlan_rx_register;
- NETDEV_GET_STATS(netdev, &jme_get_stats);
netdev->features = NETIF_F_HW_CSUM |
NETIF_F_SG |
NETIF_F_TSO |