[ARM] 5257/2: [AT91] Use SZ_ definitions and MTDPART_OFS_NXTBLK instead of hex-values
In the various AT91 board files, replace hard-coded size values (eg,
0x800000) with the SZ_ size definitions (eg, SZ_8M) from sizes.h
Also replace MTD partition offsets with MTDPART_OFS_NXTBLK.
Signed-off-by: Andrew Victor <linux@maxim.org.za>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/arch/arm/mach-at91/board-sam9263ek.c b/arch/arm/mach-at91/board-sam9263ek.c
index c51f2eb..ad71f4a 100644
--- a/arch/arm/mach-at91/board-sam9263ek.c
+++ b/arch/arm/mach-at91/board-sam9263ek.c
@@ -33,7 +33,6 @@
#include <video/atmel_lcdc.h>
-#include <mach/hardware.h>
#include <asm/setup.h>
#include <asm/mach-types.h>
#include <asm/irq.h>
@@ -42,6 +41,7 @@
#include <asm/mach/map.h>
#include <asm/mach/irq.h>
+#include <mach/hardware.h>
#include <mach/board.h>
#include <mach/gpio.h>
#include <mach/at91sam9_smc.h>
@@ -173,11 +173,11 @@
{
.name = "Partition 1",
.offset = 0,
- .size = 64 * 1024 * 1024,
+ .size = SZ_64M,
},
{
.name = "Partition 2",
- .offset = 64 * 1024 * 1024,
+ .offset = MTDPART_OFS_NXTBLK,
.size = MTDPART_SIZ_FULL,
},
};
@@ -227,7 +227,7 @@
#if defined(CONFIG_FB_ATMEL) || defined(CONFIG_FB_ATMEL_MODULE)
static struct fb_videomode at91_tft_vga_modes[] = {
{
- .name = "TX09D50VM1CCA @ 60",
+ .name = "TX09D50VM1CCA @ 60",
.refresh = 60,
.xres = 240, .yres = 320,
.pixclock = KHZ2PICOS(4965),
@@ -243,7 +243,7 @@
static struct fb_monspecs at91fb_default_monspecs = {
.manufacturer = "HIT",
- .monitor = "TX09D70VM1CCA",
+ .monitor = "TX09D70VM1CCA",
.modedb = at91_tft_vga_modes,
.modedb_len = ARRAY_SIZE(at91_tft_vga_modes),
@@ -254,7 +254,7 @@
};
#define AT91SAM9263_DEFAULT_LCDCON2 (ATMEL_LCDC_MEMOR_LITTLE \
- | ATMEL_LCDC_DISTYPE_TFT \
+ | ATMEL_LCDC_DISTYPE_TFT \
| ATMEL_LCDC_CLKMOD_ALWAYSACTIVE)
static void at91_lcdc_power_control(int on)