[MTD] devices: Clean up trailing white spaces
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
diff --git a/drivers/mtd/devices/doc2001.c b/drivers/mtd/devices/doc2001.c
index 1e70491..fcb28a6 100644
--- a/drivers/mtd/devices/doc2001.c
+++ b/drivers/mtd/devices/doc2001.c
@@ -4,7 +4,7 @@
* (c) 1999 Machine Vision Holdings, Inc.
* (c) 1999, 2000 David Woodhouse <dwmw2@infradead.org>
*
- * $Id: doc2001.c,v 1.48 2005/01/05 18:05:12 dwmw2 Exp $
+ * $Id: doc2001.c,v 1.49 2005/11/07 11:14:24 gleixner Exp $
*/
#include <linux/kernel.h>
@@ -196,10 +196,10 @@
DoC_Command(doc->virtadr, NAND_CMD_RESET, CDSN_CTRL_WP);
DoC_WaitReady(doc->virtadr);
- /* Read the NAND chip ID: 1. Send ReadID command */
+ /* Read the NAND chip ID: 1. Send ReadID command */
DoC_Command(doc->virtadr, NAND_CMD_READID, CDSN_CTRL_WP);
- /* Read the NAND chip ID: 2. Send address byte zero */
+ /* Read the NAND chip ID: 2. Send address byte zero */
DoC_Address(doc->virtadr, 1, 0x00, CDSN_CTRL_WP, 0x00);
/* Read the manufacturer and device id codes of the flash device through
@@ -223,7 +223,7 @@
for (j = 0; nand_manuf_ids[j].id != 0x0; j++) {
if (nand_manuf_ids[j].id == mfr)
break;
- }
+ }
printk(KERN_INFO "Flash chip found: Manufacturer ID: %2.2X, "
"Chip ID: %2.2X (%s:%s)\n",
mfr, id, nand_manuf_ids[j].name, nand_flash_ids[i].name);
@@ -275,7 +275,7 @@
return;
}
- /* Fill out the chip array with {floor, chipno} for each
+ /* Fill out the chip array with {floor, chipno} for each
* detected chip in the device. */
for (floor = 0, ret = 0; floor < MAX_FLOORS_MIL; floor++) {
for (chip = 0 ; chip < numchips[floor] ; chip++) {
@@ -309,7 +309,7 @@
tmp2 = ReadDOC(doc2->virtadr, AliasResolution);
if (tmp1 != tmp2)
return 0;
-
+
WriteDOC((tmp1+1) % 0xff, doc1->virtadr, AliasResolution);
tmp2 = ReadDOC(doc2->virtadr, AliasResolution);
if (tmp2 == (tmp1+1) % 0xff)
@@ -425,7 +425,7 @@
return -EINVAL;
/* Don't allow a single read to cross a 512-byte block boundary */
- if (from + len > ((from | 0x1ff) + 1))
+ if (from + len > ((from | 0x1ff) + 1))
len = ((from | 0x1ff) + 1) - from;
/* Find the chip which is to be used and select it */
@@ -552,7 +552,7 @@
#if 0
/* Don't allow a single write to cross a 512-byte block boundary */
- if (to + len > ( (to | 0x1ff) + 1))
+ if (to + len > ( (to | 0x1ff) + 1))
len = ((to | 0x1ff) + 1) - to;
#else
/* Don't allow writes which aren't exactly one block */
@@ -632,7 +632,7 @@
/* write the block status BLOCK_USED (0x5555) at the end of ECC data
FIXME: this is only a hack for programming the IPL area for LinuxBIOS
- and should be replace with proper codes in user space utilities */
+ and should be replace with proper codes in user space utilities */
WriteDOC(0x55, docptr, Mil_CDSN_IO);
WriteDOC(0x55, docptr, Mil_CDSN_IO + 1);
@@ -802,7 +802,7 @@
void __iomem *docptr = this->virtadr;
struct Nand *mychip = &this->chips[ofs >> this->chipshift];
- if (len != mtd->erasesize)
+ if (len != mtd->erasesize)
printk(KERN_WARNING "Erase not right size (%x != %x)n",
len, mtd->erasesize);
@@ -870,9 +870,9 @@
while ((mtd=docmillist)) {
this = mtd->priv;
docmillist = this->nextdoc;
-
+
del_mtd_device(mtd);
-
+
iounmap(this->virtadr);
kfree(this->chips);
kfree(mtd);