ARM: dtsi: sunxi: add common VBUS regulator
Until now the regulator nodes for powering USB VBUS
existed only for the two host controllers. Now the regulator
is added for USB OTG too.
Signed-off-by: Roman Byshko <rbyshko@gmail.com>
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
diff --git a/arch/arm/boot/dts/sunxi-common-regulators.dtsi b/arch/arm/boot/dts/sunxi-common-regulators.dtsi
index fa69adf..be5cfa3 100644
--- a/arch/arm/boot/dts/sunxi-common-regulators.dtsi
+++ b/arch/arm/boot/dts/sunxi-common-regulators.dtsi
@@ -57,6 +57,13 @@
allwinner,pull = <0>;
};
+ usb0_vbus_pin_a: usb0_vbus_pin@0 {
+ allwinner,pins = "PB9";
+ allwinner,function = "gpio_out";
+ allwinner,drive = <0>;
+ allwinner,pull = <0>;
+ };
+
usb1_vbus_pin_a: usb1_vbus_pin@0 {
allwinner,pins = "PH6";
allwinner,function = "gpio_out";
@@ -85,6 +92,18 @@
status = "disabled";
};
+ reg_usb0_vbus: usb0-vbus {
+ compatible = "regulator-fixed";
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb0_vbus_pin_a>;
+ regulator-name = "usb0-vbus";
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ enable-active-high;
+ gpio = <&pio 1 9 0>;
+ status = "disabled";
+ };
+
reg_usb1_vbus: usb1-vbus {
compatible = "regulator-fixed";
pinctrl-names = "default";