e1000e: cleanup unnecessary line breaks
Cuddle broken lines where appropriate.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/e1000e/netdev.c b/drivers/net/ethernet/intel/e1000e/netdev.c
index 5337137..b085ce1 100644
--- a/drivers/net/ethernet/intel/e1000e/netdev.c
+++ b/drivers/net/ethernet/intel/e1000e/netdev.c
@@ -219,9 +219,8 @@
if (netdev) {
dev_info(&adapter->pdev->dev, "Net device Info\n");
pr_info("Device Name state trans_start last_rx\n");
- pr_info("%-15s %016lX %016lX %016lX\n",
- netdev->name, netdev->state, netdev->trans_start,
- netdev->last_rx);
+ pr_info("%-15s %016lX %016lX %016lX\n", netdev->name,
+ netdev->state, netdev->trans_start, netdev->last_rx);
}
/* Print Registers */
@@ -755,8 +754,7 @@
cpu_to_le64(ps_page->dma);
}
- skb = __netdev_alloc_skb_ip_align(netdev,
- adapter->rx_ps_bsize0,
+ skb = __netdev_alloc_skb_ip_align(netdev, adapter->rx_ps_bsize0,
gfp);
if (!skb) {
@@ -937,10 +935,8 @@
cleaned = true;
cleaned_count++;
- dma_unmap_single(&pdev->dev,
- buffer_info->dma,
- adapter->rx_buffer_len,
- DMA_FROM_DEVICE);
+ dma_unmap_single(&pdev->dev, buffer_info->dma,
+ adapter->rx_buffer_len, DMA_FROM_DEVICE);
buffer_info->dma = 0;
length = le16_to_cpu(rx_desc->wb.upper.length);
@@ -1082,8 +1078,7 @@
if (test_bit(__E1000_DOWN, &adapter->state))
return;
- if (!adapter->tx_hang_recheck &&
- (adapter->flags2 & FLAG2_DMA_BURST)) {
+ if (!adapter->tx_hang_recheck && (adapter->flags2 & FLAG2_DMA_BURST)) {
/* May be block on write-back, flush and detect again
* flush pending descriptor writebacks to memory
*/
@@ -1125,19 +1120,10 @@
"PHY 1000BASE-T Status <%x>\n"
"PHY Extended Status <%x>\n"
"PCI Status <%x>\n",
- readl(tx_ring->head),
- readl(tx_ring->tail),
- tx_ring->next_to_use,
- tx_ring->next_to_clean,
- tx_ring->buffer_info[eop].time_stamp,
- eop,
- jiffies,
- eop_desc->upper.fields.status,
- er32(STATUS),
- phy_status,
- phy_1000t_status,
- phy_ext_status,
- pci_status);
+ readl(tx_ring->head), readl(tx_ring->tail), tx_ring->next_to_use,
+ tx_ring->next_to_clean, tx_ring->buffer_info[eop].time_stamp,
+ eop, jiffies, eop_desc->upper.fields.status, er32(STATUS),
+ phy_status, phy_1000t_status, phy_ext_status, pci_status);
/* Suggest workaround for known h/w issue */
if ((hw->mac.type == e1000_pchlan) && (er32(CTRL) & E1000_CTRL_TFCE))
@@ -2811,8 +2797,7 @@
u16 vid = adapter->hw.mng_cookie.vlan_id;
u16 old_vid = adapter->mng_vlan_id;
- if (adapter->hw.mng_cookie.status &
- E1000_MNG_DHCP_COOKIE_STATUS_VLAN) {
+ if (adapter->hw.mng_cookie.status & E1000_MNG_DHCP_COOKIE_STATUS_VLAN) {
e1000_vlan_rx_add_vid(netdev, vid);
adapter->mng_vlan_id = vid;
}
@@ -3090,19 +3075,17 @@
/* Enable Packet split descriptors */
rctl |= E1000_RCTL_DTYP_PS;
- psrctl |= adapter->rx_ps_bsize0 >>
- E1000_PSRCTL_BSIZE0_SHIFT;
+ psrctl |= adapter->rx_ps_bsize0 >> E1000_PSRCTL_BSIZE0_SHIFT;
switch (adapter->rx_ps_pages) {
case 3:
- psrctl |= PAGE_SIZE <<
- E1000_PSRCTL_BSIZE3_SHIFT;
+ psrctl |= PAGE_SIZE << E1000_PSRCTL_BSIZE3_SHIFT;
+ /* fall-through */
case 2:
- psrctl |= PAGE_SIZE <<
- E1000_PSRCTL_BSIZE2_SHIFT;
+ psrctl |= PAGE_SIZE << E1000_PSRCTL_BSIZE2_SHIFT;
+ /* fall-through */
case 1:
- psrctl |= PAGE_SIZE >>
- E1000_PSRCTL_BSIZE1_SHIFT;
+ psrctl |= PAGE_SIZE >> E1000_PSRCTL_BSIZE1_SHIFT;
break;
}
@@ -3753,8 +3736,7 @@
* but don't include ethernet FCS because hardware appends it
*/
min_tx_space = (adapter->max_frame_size +
- sizeof(struct e1000_tx_desc) -
- ETH_FCS_LEN) * 2;
+ sizeof(struct e1000_tx_desc) - ETH_FCS_LEN) * 2;
min_tx_space = ALIGN(min_tx_space, 1024);
min_tx_space >>= 10;
/* software strips receive CRC, so leave room for it */
@@ -4262,8 +4244,7 @@
e1000e_power_up_phy(adapter);
adapter->mng_vlan_id = E1000_MNG_VLAN_NONE;
- if ((adapter->hw.mng_cookie.status &
- E1000_MNG_DHCP_COOKIE_STATUS_VLAN))
+ if ((adapter->hw.mng_cookie.status & E1000_MNG_DHCP_COOKIE_STATUS_VLAN))
e1000_update_mng_vlan(adapter);
/* DMA latency requirement to workaround jumbo issue */
@@ -4365,8 +4346,7 @@
/* kill manageability vlan ID if supported, but not if a vlan with
* the same ID is registered on the host OS (let 8021q kill it)
*/
- if (adapter->hw.mng_cookie.status &
- E1000_MNG_DHCP_COOKIE_STATUS_VLAN)
+ if (adapter->hw.mng_cookie.status & E1000_MNG_DHCP_COOKIE_STATUS_VLAN)
e1000_vlan_rx_kill_vid(netdev, adapter->mng_vlan_id);
/* If AMT is enabled, let the firmware know that the network