[libata] sata_mv: don't touch reserved bits in EDMA config register
The code in mv_edma_cfg() reflected its 60xx origins, by doing things
[slightly] incorrectly on the older 50xx and newer 6042/7042 chips.
Clean up the EDMA configuration setup such that, each chip family
carefully initializes its own EDMA setup.
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c
index d724bc7..cc59aca 100644
--- a/drivers/ata/sata_mv.c
+++ b/drivers/ata/sata_mv.c
@@ -814,23 +814,27 @@
u32 cfg = readl(port_mmio + EDMA_CFG_OFS);
/* set up non-NCQ EDMA configuration */
- cfg &= ~0x1f; /* clear queue depth */
- cfg &= ~EDMA_CFG_NCQ; /* clear NCQ mode */
cfg &= ~(1 << 9); /* disable equeue */
- if (IS_GEN_I(hpriv))
+ if (IS_GEN_I(hpriv)) {
+ cfg &= ~0x1f; /* clear queue depth */
cfg |= (1 << 8); /* enab config burst size mask */
+ }
- else if (IS_GEN_II(hpriv))
+ else if (IS_GEN_II(hpriv)) {
+ cfg &= ~0x1f; /* clear queue depth */
cfg |= EDMA_CFG_RD_BRST_EXT | EDMA_CFG_WR_BUFF_LEN;
+ cfg &= ~(EDMA_CFG_NCQ | EDMA_CFG_NCQ_GO_ON_ERR); /* clear NCQ */
+ }
else if (IS_GEN_IIE(hpriv)) {
- cfg |= (1 << 23); /* dis RX PM port mask */
- cfg &= ~(1 << 16); /* dis FIS-based switching (for now) */
+ cfg |= (1 << 23); /* do not mask PM field in rx'd FIS */
+ cfg |= (1 << 22); /* enab 4-entry host queue cache */
cfg &= ~(1 << 19); /* dis 128-entry queue (for now?) */
cfg |= (1 << 18); /* enab early completion */
- cfg |= (1 << 17); /* enab host q cache */
- cfg |= (1 << 22); /* enab cutthrough */
+ cfg |= (1 << 17); /* enab cut-through (dis stor&forwrd) */
+ cfg &= ~(1 << 16); /* dis FIS-based switching (for now) */
+ cfg &= ~(EDMA_CFG_NCQ | EDMA_CFG_NCQ_GO_ON_ERR); /* clear NCQ */
}
writelfl(cfg, port_mmio + EDMA_CFG_OFS);