net: bug fix for vlan + gro issue

Traffic (tcp) doesnot start on a vlan interface when gro is enabled.
Even the tcp handshake was not taking place.
This is because, the eth_type_trans call before the netif_receive_skb
in napi_gro_finish() resets the skb->dev to napi->dev from the previously
set vlan netdev interface. This causes the ip_route_input to drop the
incoming packet considering it as a packet coming from a martian source.

I could repro this on 2.6.32.7 (stable) and 2.6.33-rc7.
With this fix, the traffic starts and the test runs fine on both vlan
and non-vlan interfaces.

CC: Herbert Xu <herbert@gondor.apana.org.au>
CC: Patrick McHardy <kaber@trash.net>
Signed-off-by: Ajit Khaparde <ajitk@serverengines.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/core/dev.c b/net/core/dev.c
index d1cf53d..1968980 100644
--- a/net/core/dev.c
+++ b/net/core/dev.c
@@ -2813,7 +2813,7 @@
 	switch (ret) {
 	case GRO_NORMAL:
 	case GRO_HELD:
-		skb->protocol = eth_type_trans(skb, napi->dev);
+		skb->protocol = eth_type_trans(skb, skb->dev);
 
 		if (ret == GRO_HELD)
 			skb_gro_pull(skb, -ETH_HLEN);