[PATCH] x86-64/i386: Use common X86_PM_TIMER option and make it EMBEDDED

This makes x86-64 use the common X86_PM_TIMER Kconfig entry in drivers/acpi

And since PM timer is needed for correct timing on a lot of systems
now (e.g. AMD dual cores) and we often get bug reports from people
who forgot to set it make it depend on CONFIG_EMBEDDED. x86-64 had
this change before and it's a good thing.

I also fixed the description slightly to make this more clear.

Cc: len.brown@intel.com

Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/arch/x86_64/Kconfig b/arch/x86_64/Kconfig
index 2f9deca..babc31b 100644
--- a/arch/x86_64/Kconfig
+++ b/arch/x86_64/Kconfig
@@ -354,21 +354,6 @@
 	  as it is off-chip.  You can find the HPET spec at
 	  <http://www.intel.com/hardwaredesign/hpetspec.htm>.
 
-config X86_PM_TIMER
-	bool "PM timer" if EMBEDDED
-	depends on ACPI
-	default y
-	help
-	  Support the ACPI PM timer for time keeping. This is slow,
-	  but is useful on some chipsets without HPET on systems with more
-	  than one CPU. On a single processor or single socket multi core
-	  system it is normally not required.
-	  When the PM timer is active 64bit vsyscalls are disabled
-	  and should not be enabled (/proc/sys/kernel/vsyscall64 should
-	  not be changed).
-	  The kernel selects the PM timer only as a last resort, so it is
-	  useful to enable just in case.
-
 config HPET_EMULATE_RTC
 	bool "Provide RTC interrupt"
 	depends on HPET_TIMER && RTC=y
diff --git a/drivers/acpi/Kconfig b/drivers/acpi/Kconfig
index 0cce28c..9dc2fbe 100644
--- a/drivers/acpi/Kconfig
+++ b/drivers/acpi/Kconfig
@@ -285,9 +285,8 @@
 	  dump your ACPI DSDT table using /proc/acpi/dsdt.
 
 config X86_PM_TIMER
-	bool "Power Management Timer Support"
+	bool "Power Management Timer Support" if EMBEDDED
 	depends on X86
-	depends on !X86_64
 	default y
 	help
 	  The Power Management Timer is available on all ACPI-capable,
@@ -298,9 +297,8 @@
 	  voltage scaling, unlike the commonly used Time Stamp Counter
 	  (TSC) timing source.
 
-	  So, if you see messages like 'Losing too many ticks!' in the
-	  kernel logs, and/or you are using this on a notebook which
-	  does not yet have an HPET, you should say "Y" here.
+	  You should nearly always say Y here because many modern
+	  systems require this timer. 
 
 config ACPI_CONTAINER
 	tristate "ACPI0004,PNP0A05 and PNP0A06 Container Driver (EXPERIMENTAL)"