e1000e: cleanup whitespace
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/e1000e/netdev.c b/drivers/net/ethernet/intel/e1000e/netdev.c
index a27e3bc..ad5f434 100644
--- a/drivers/net/ethernet/intel/e1000e/netdev.c
+++ b/drivers/net/ethernet/intel/e1000e/netdev.c
@@ -1196,7 +1196,7 @@
while ((eop_desc->upper.data & cpu_to_le32(E1000_TXD_STAT_DD)) &&
(count < tx_ring->count)) {
bool cleaned = false;
- rmb(); /* read buffer_info after eop_desc */
+ rmb(); /* read buffer_info after eop_desc */
for (; !cleaned; count++) {
tx_desc = E1000_TX_DESC(*tx_ring, i);
buffer_info = &tx_ring->buffer_info[i];
@@ -1385,7 +1385,7 @@
skb_put(skb, l1);
goto copydone;
- } /* if */
+ } /* if */
}
for (j = 0; j < PS_PAGE_BUFFERS; j++) {
@@ -1800,7 +1800,7 @@
u32 rctl, icr = er32(ICR);
if (!icr || test_bit(__E1000_DOWN, &adapter->state))
- return IRQ_NONE; /* Not our interrupt */
+ return IRQ_NONE; /* Not our interrupt */
/* IMS will not auto-mask if INT_ASSERTED is not set, and if it is
* not set, then the adapter didn't send an interrupt
@@ -2487,7 +2487,7 @@
else if ((packets < 5) && (bytes > 512))
retval = low_latency;
break;
- case low_latency: /* 50 usec aka 20000 ints/s */
+ case low_latency: /* 50 usec aka 20000 ints/s */
if (bytes > 10000) {
/* this if handles the TSO accounting */
if (bytes / packets > 8000)
@@ -2502,7 +2502,7 @@
retval = lowest_latency;
}
break;
- case bulk_latency: /* 250 usec aka 4000 ints/s */
+ case bulk_latency: /* 250 usec aka 4000 ints/s */
if (bytes > 25000) {
if (packets > 35)
retval = low_latency;
@@ -2554,7 +2554,7 @@
new_itr = 70000;
break;
case low_latency:
- new_itr = 20000; /* aka hwitr = ~200 */
+ new_itr = 20000; /* aka hwitr = ~200 */
break;
case bulk_latency:
new_itr = 4000;
@@ -3104,13 +3104,13 @@
/* UPE and MPE will be handled by normal PROMISC logic
* in e1000e_set_rx_mode
*/
- rctl |= (E1000_RCTL_SBP | /* Receive bad packets */
- E1000_RCTL_BAM | /* RX All Bcast Pkts */
- E1000_RCTL_PMCF); /* RX All MAC Ctrl Pkts */
+ rctl |= (E1000_RCTL_SBP | /* Receive bad packets */
+ E1000_RCTL_BAM | /* RX All Bcast Pkts */
+ E1000_RCTL_PMCF); /* RX All MAC Ctrl Pkts */
- rctl &= ~(E1000_RCTL_VFE | /* Disable VLAN filter */
- E1000_RCTL_DPF | /* Allow filtered pause */
- E1000_RCTL_CFIEN); /* Dis VLAN CFIEN Filter */
+ rctl &= ~(E1000_RCTL_VFE | /* Disable VLAN filter */
+ E1000_RCTL_DPF | /* Allow filtered pause */
+ E1000_RCTL_CFIEN); /* Dis VLAN CFIEN Filter */
/* Do not mess with E1000_CTRL_VME, it affects transmit as well,
* and that breaks VLANs.
*/
@@ -3799,7 +3799,7 @@
hwm = min(((pba << 10) * 9 / 10),
((pba << 10) - adapter->max_frame_size));
- fc->high_water = hwm & E1000_FCRTH_RTH; /* 8-byte granularity */
+ fc->high_water = hwm & E1000_FCRTH_RTH; /* 8-byte granularity */
fc->low_water = fc->high_water - 8;
break;
case e1000_pchlan:
@@ -3808,10 +3808,10 @@
*/
if (adapter->netdev->mtu > ETH_DATA_LEN) {
fc->high_water = 0x3500;
- fc->low_water = 0x1500;
+ fc->low_water = 0x1500;
} else {
fc->high_water = 0x5000;
- fc->low_water = 0x3000;
+ fc->low_water = 0x3000;
}
fc->refresh_time = 0x1000;
break;
@@ -4581,7 +4581,7 @@
adapter->stats.crcerrs += er32(CRCERRS);
adapter->stats.gprc += er32(GPRC);
adapter->stats.gorc += er32(GORCL);
- er32(GORCH); /* Clear gorc */
+ er32(GORCH); /* Clear gorc */
adapter->stats.bprc += er32(BPRC);
adapter->stats.mprc += er32(MPRC);
adapter->stats.roc += er32(ROC);
@@ -4614,7 +4614,7 @@
adapter->stats.xofftxc += er32(XOFFTXC);
adapter->stats.gptc += er32(GPTC);
adapter->stats.gotc += er32(GOTCL);
- er32(GOTCH); /* Clear gotc */
+ er32(GOTCH); /* Clear gotc */
adapter->stats.rnbc += er32(RNBC);
adapter->stats.ruc += er32(RUC);
@@ -5106,13 +5106,13 @@
context_desc = E1000_CONTEXT_DESC(*tx_ring, i);
buffer_info = &tx_ring->buffer_info[i];
- context_desc->lower_setup.ip_fields.ipcss = ipcss;
- context_desc->lower_setup.ip_fields.ipcso = ipcso;
- context_desc->lower_setup.ip_fields.ipcse = cpu_to_le16(ipcse);
+ context_desc->lower_setup.ip_fields.ipcss = ipcss;
+ context_desc->lower_setup.ip_fields.ipcso = ipcso;
+ context_desc->lower_setup.ip_fields.ipcse = cpu_to_le16(ipcse);
context_desc->upper_setup.tcp_fields.tucss = tucss;
context_desc->upper_setup.tcp_fields.tucso = tucso;
context_desc->upper_setup.tcp_fields.tucse = 0;
- context_desc->tcp_seg_setup.fields.mss = cpu_to_le16(mss);
+ context_desc->tcp_seg_setup.fields.mss = cpu_to_le16(mss);
context_desc->tcp_seg_setup.fields.hdr_len = hdr_len;
context_desc->cmd_and_length = cpu_to_le32(cmd_length);
@@ -5363,7 +5363,7 @@
static int e1000_transfer_dhcp_info(struct e1000_adapter *adapter,
struct sk_buff *skb)
{
- struct e1000_hw *hw = &adapter->hw;
+ struct e1000_hw *hw = &adapter->hw;
u16 length, offset;
if (vlan_tx_tag_present(skb) &&
@@ -6259,7 +6259,7 @@
e1000_intr_msi(adapter->pdev->irq, netdev);
enable_irq(adapter->pdev->irq);
break;
- default: /* E1000E_INT_MODE_LEGACY */
+ default: /* E1000E_INT_MODE_LEGACY */
disable_irq(adapter->pdev->irq);
e1000_intr(adapter->pdev->irq, netdev);
enable_irq(adapter->pdev->irq);
@@ -6589,9 +6589,9 @@
adapter->eee_advert = MDIO_EEE_100TX | MDIO_EEE_1000T;
/* construct the net_device struct */
- netdev->netdev_ops = &e1000e_netdev_ops;
+ netdev->netdev_ops = &e1000e_netdev_ops;
e1000e_set_ethtool_ops(netdev);
- netdev->watchdog_timeo = 5 * HZ;
+ netdev->watchdog_timeo = 5 * HZ;
netif_napi_add(netdev, &adapter->napi, e1000e_poll, 64);
strlcpy(netdev->name, pci_name(pdev), sizeof(netdev->name));
@@ -7034,7 +7034,6 @@
}
module_exit(e1000_exit_module);
-
MODULE_AUTHOR("Intel Corporation, <linux.nics@intel.com>");
MODULE_DESCRIPTION("Intel(R) PRO/1000 Network Driver");
MODULE_LICENSE("GPL");