dm: do not override error code returned from dm_get_device()
Some of the device mapper targets override the error code returned by
dm_get_device() and return either -EINVAL or -ENXIO. There is nothing
gained by this override. It is better to propagate the returned error
code unchanged to caller.
This work was motivated by hitting an issue where the underlying device
was busy but -EINVAL was being returned. After this change we get
-EBUSY instead and it is easier to figure out the problem.
Signed-off-by: Vivek Goyal <vgoyal@redhat.com>
Signed-off-by: Mike Snitzer <snitzer@redhat.com>
diff --git a/drivers/md/dm-raid1.c b/drivers/md/dm-raid1.c
index d83696b..933a1fd 100644
--- a/drivers/md/dm-raid1.c
+++ b/drivers/md/dm-raid1.c
@@ -943,16 +943,18 @@
{
unsigned long long offset;
char dummy;
+ int ret;
if (sscanf(argv[1], "%llu%c", &offset, &dummy) != 1) {
ti->error = "Invalid offset";
return -EINVAL;
}
- if (dm_get_device(ti, argv[0], dm_table_get_mode(ti->table),
- &ms->mirror[mirror].dev)) {
+ ret = dm_get_device(ti, argv[0], dm_table_get_mode(ti->table),
+ &ms->mirror[mirror].dev);
+ if (ret) {
ti->error = "Device lookup failure";
- return -ENXIO;
+ return ret;
}
ms->mirror[mirror].ms = ms;