pcmcia: move Vpp setup to struct pcmcia_device
Some drivers prefer to explicitly set Vpp. Instead of passing the
voltage inside config_req_t, store it in struct pcmcia_device.
CC: linux-ide@vger.kernel.org
CC: netdev@vger.kernel.org
CC: linux-mtd@lists.infradead.org
CC: linux-wireless@vger.kernel.org
CC: linux-serial@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: linux-scsi@vger.kernel.org
Acked-by: Gustavo F. Padovan <padovan@profusion.mobi> (for drivers/bluetooth)
Tested-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/wireless/atmel_cs.c b/drivers/net/wireless/atmel_cs.c
index 3b63216..479f508 100644
--- a/drivers/net/wireless/atmel_cs.c
+++ b/drivers/net/wireless/atmel_cs.c
@@ -183,9 +183,9 @@
/* Use power settings for Vcc and Vpp if present */
/* Note that the CIS values need to be rescaled */
if (cfg->vpp1.present & (1<<CISTPL_POWER_VNOM))
- p_dev->conf.Vpp = cfg->vpp1.param[CISTPL_POWER_VNOM]/10000;
+ p_dev->vpp = cfg->vpp1.param[CISTPL_POWER_VNOM]/10000;
else if (dflt->vpp1.present & (1<<CISTPL_POWER_VNOM))
- p_dev->conf.Vpp = dflt->vpp1.param[CISTPL_POWER_VNOM]/10000;
+ p_dev->vpp = dflt->vpp1.param[CISTPL_POWER_VNOM]/10000;
p_dev->conf.Attributes |= CONF_ENABLE_IRQ;