pcmcia: move Vpp setup to struct pcmcia_device
Some drivers prefer to explicitly set Vpp. Instead of passing the
voltage inside config_req_t, store it in struct pcmcia_device.
CC: linux-ide@vger.kernel.org
CC: netdev@vger.kernel.org
CC: linux-mtd@lists.infradead.org
CC: linux-wireless@vger.kernel.org
CC: linux-serial@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: linux-scsi@vger.kernel.org
Acked-by: Gustavo F. Padovan <padovan@profusion.mobi> (for drivers/bluetooth)
Tested-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/wireless/hostap/hostap_cs.c b/drivers/net/wireless/hostap/hostap_cs.c
index ba54d1b..3f35dd4 100644
--- a/drivers/net/wireless/hostap/hostap_cs.c
+++ b/drivers/net/wireless/hostap/hostap_cs.c
@@ -508,9 +508,9 @@
}
if (cfg->vpp1.present & (1 << CISTPL_POWER_VNOM))
- p_dev->conf.Vpp = cfg->vpp1.param[CISTPL_POWER_VNOM] / 10000;
+ p_dev->vpp = cfg->vpp1.param[CISTPL_POWER_VNOM] / 10000;
else if (dflt->vpp1.present & (1 << CISTPL_POWER_VNOM))
- p_dev->conf.Vpp = dflt->vpp1.param[CISTPL_POWER_VNOM] / 10000;
+ p_dev->vpp = dflt->vpp1.param[CISTPL_POWER_VNOM] / 10000;
/* Do we need to allocate an interrupt? */
p_dev->conf.Attributes |= CONF_ENABLE_IRQ;
@@ -605,9 +605,9 @@
/* Finally, report what we've done */
printk(KERN_INFO "%s: index 0x%02x: ",
dev_info, link->conf.ConfigIndex);
- if (link->conf.Vpp)
- printk(", Vpp %d.%d", link->conf.Vpp / 10,
- link->conf.Vpp % 10);
+ if (link->vpp)
+ printk(", Vpp %d.%d", link->vpp / 10,
+ link->vpp % 10);
if (link->conf.Attributes & CONF_ENABLE_IRQ)
printk(", irq %d", link->irq);
if (link->resource[0])