[S390] convert some assembler to C.
Convert GET_IPL_DEVICE assembler macro to C function.
Signed-off-by: Heiko Carstens <heiko.carstens@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
diff --git a/drivers/s390/cio/cio.c b/drivers/s390/cio/cio.c
index 050963f..61eb7ca 100644
--- a/drivers/s390/cio/cio.c
+++ b/drivers/s390/cio/cio.c
@@ -16,11 +16,10 @@
#include <linux/device.h>
#include <linux/kernel_stat.h>
#include <linux/interrupt.h>
-
#include <asm/cio.h>
#include <asm/delay.h>
#include <asm/irq.h>
-
+#include <asm/setup.h>
#include "airq.h"
#include "cio.h"
#include "css.h"
@@ -909,3 +908,38 @@
cio_reset_channel_paths();
do_reipl_asm(*((__u32*)&schid));
}
+
+extern struct schib ipl_schib;
+
+/*
+ * ipl_save_parameters gets called very early. It is not allowed to access
+ * anything in the bss section at all. The bss section is not cleared yet,
+ * but may contain some ipl parameters written by the firmware.
+ * These parameters (if present) are copied to 0x2000.
+ * To avoid corruption of the ipl parameters, all variables used by this
+ * function must reside on the stack or in the data section.
+ */
+void ipl_save_parameters(void)
+{
+ struct subchannel_id schid;
+ unsigned int *ipl_ptr;
+ void *src, *dst;
+
+ schid = *(struct subchannel_id *)__LC_SUBCHANNEL_ID;
+ if (!schid.one)
+ return;
+ if (stsch(schid, &ipl_schib))
+ return;
+ if (!ipl_schib.pmcw.dnv)
+ return;
+ ipl_devno = ipl_schib.pmcw.dev;
+ ipl_flags |= IPL_DEVNO_VALID;
+ if (!ipl_schib.pmcw.qf)
+ return;
+ ipl_flags |= IPL_PARMBLOCK_VALID;
+ ipl_ptr = (unsigned int *)__LC_IPL_PARMBLOCK_PTR;
+ src = (void *)(unsigned long)*ipl_ptr;
+ dst = (void *)IPL_PARMBLOCK_ORIGIN;
+ memmove(dst, src, PAGE_SIZE);
+ *ipl_ptr = IPL_PARMBLOCK_ORIGIN;
+}