ALSA: hda - Add setup hook to ALC preset struct
Added setup hook to ALC preset struct to be called at in the parser
but not at each init callback.
This can be used for setting up the static pins, etc, while the
init hook should be used for updating the status again.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
diff --git a/sound/pci/hda/patch_realtek.c b/sound/pci/hda/patch_realtek.c
index 5156c4f..b2e097b 100644
--- a/sound/pci/hda/patch_realtek.c
+++ b/sound/pci/hda/patch_realtek.c
@@ -379,6 +379,7 @@
unsigned int num_mux_defs;
const struct hda_input_mux *input_mux;
void (*unsol_event)(struct hda_codec *, unsigned int);
+ void (*setup)(struct hda_codec *);
void (*init_hook)(struct hda_codec *);
#ifdef CONFIG_SND_HDA_POWER_SAVE
struct hda_amp_list *loopbacks;
@@ -851,9 +852,10 @@
/*
* set up from the preset table
*/
-static void setup_preset(struct alc_spec *spec,
+static void setup_preset(struct hda_codec *codec,
const struct alc_config_preset *preset)
{
+ struct alc_spec *spec = codec->spec;
int i;
for (i = 0; i < ARRAY_SIZE(preset->mixers) && preset->mixers[i]; i++)
@@ -895,6 +897,9 @@
#ifdef CONFIG_SND_HDA_POWER_SAVE
spec->loopback.amplist = preset->loopbacks;
#endif
+
+ if (preset->setup)
+ preset->setup(codec);
}
/* Enable GPIO mask and set output */
@@ -4762,7 +4767,7 @@
}
if (board_config != ALC880_AUTO)
- setup_preset(spec, &alc880_presets[board_config]);
+ setup_preset(codec, &alc880_presets[board_config]);
spec->stream_analog_playback = &alc880_pcm_analog_playback;
spec->stream_analog_capture = &alc880_pcm_analog_capture;
@@ -6406,7 +6411,7 @@
}
if (board_config != ALC260_AUTO)
- setup_preset(spec, &alc260_presets[board_config]);
+ setup_preset(codec, &alc260_presets[board_config]);
spec->stream_analog_playback = &alc260_pcm_analog_playback;
spec->stream_analog_capture = &alc260_pcm_analog_capture;
@@ -9720,7 +9725,7 @@
}
if (board_config != ALC882_AUTO)
- setup_preset(spec, &alc882_presets[board_config]);
+ setup_preset(codec, &alc882_presets[board_config]);
spec->stream_analog_playback = &alc882_pcm_analog_playback;
spec->stream_analog_capture = &alc882_pcm_analog_capture;
@@ -11594,7 +11599,7 @@
}
if (board_config != ALC262_AUTO)
- setup_preset(spec, &alc262_presets[board_config]);
+ setup_preset(codec, &alc262_presets[board_config]);
spec->stream_analog_playback = &alc262_pcm_analog_playback;
spec->stream_analog_capture = &alc262_pcm_analog_capture;
@@ -12659,7 +12664,7 @@
}
if (board_config != ALC268_AUTO)
- setup_preset(spec, &alc268_presets[board_config]);
+ setup_preset(codec, &alc268_presets[board_config]);
spec->stream_analog_playback = &alc268_pcm_analog_playback;
spec->stream_analog_capture = &alc268_pcm_analog_capture;
@@ -13483,7 +13488,7 @@
}
if (board_config != ALC269_AUTO)
- setup_preset(spec, &alc269_presets[board_config]);
+ setup_preset(codec, &alc269_presets[board_config]);
if (codec->subsystem_id == 0x17aa3bf8) {
/* Due to a hardware problem on Lenovo Ideadpad, we need to
@@ -14636,7 +14641,7 @@
}
if (board_config != ALC861_AUTO)
- setup_preset(spec, &alc861_presets[board_config]);
+ setup_preset(codec, &alc861_presets[board_config]);
spec->stream_analog_playback = &alc861_pcm_analog_playback;
spec->stream_analog_capture = &alc861_pcm_analog_capture;
@@ -15560,7 +15565,7 @@
}
if (board_config != ALC861VD_AUTO)
- setup_preset(spec, &alc861vd_presets[board_config]);
+ setup_preset(codec, &alc861vd_presets[board_config]);
if (codec->vendor_id == 0x10ec0660) {
/* always turn on EAPD */
@@ -17468,7 +17473,7 @@
}
if (board_config != ALC662_AUTO)
- setup_preset(spec, &alc662_presets[board_config]);
+ setup_preset(codec, &alc662_presets[board_config]);
spec->stream_analog_playback = &alc662_pcm_analog_playback;
spec->stream_analog_capture = &alc662_pcm_analog_capture;