ath5k: fixing retries in ath5k_hw_setup_4word_tx_desc
The rate control algorithm, default is Minstrel for ath5k, determines
the number of retries to use for each rate. However, there exists in
ath5k_hw_setup_4word_tx_desc (which is called for AR5212 like devices)
a set number of retries defined by AR5K_TUNE_HWTXTRIES. The set
number of tries is added to the tx_tries0 variable setup by the rate
control algorithm. This changes the number of retries the rate
control algorithm considers necessary. By removing the
AR5K_TUNE_HWTXTRIES from the retry calculation the rate control
algorithm is given control over the number of retries.
Signed-off-by: Andrew Blaich <ablaich@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath5k/desc.c b/drivers/net/wireless/ath/ath5k/desc.c
index aebb31f..9d920fb 100644
--- a/drivers/net/wireless/ath/ath5k/desc.c
+++ b/drivers/net/wireless/ath/ath5k/desc.c
@@ -231,7 +231,7 @@
AR5K_REG_SM(antenna_mode, AR5K_4W_TX_DESC_CTL0_ANT_MODE_XMIT);
tx_ctl->tx_control_1 |= AR5K_REG_SM(type,
AR5K_4W_TX_DESC_CTL1_FRAME_TYPE);
- tx_ctl->tx_control_2 = AR5K_REG_SM(tx_tries0 + AR5K_TUNE_HWTXTRIES,
+ tx_ctl->tx_control_2 = AR5K_REG_SM(tx_tries0,
AR5K_4W_TX_DESC_CTL2_XMIT_TRIES0);
tx_ctl->tx_control_3 = tx_rate0 & AR5K_4W_TX_DESC_CTL3_XMIT_RATE0;