net: dsa: Centralise code for reading the temperature sensor
The method to read the temperature used in the mve6123_61_65 driver
can also be used for other chips. Move the code into the shared code
base of mv88e6xxx.c.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/dsa/mv88e6xxx.c b/drivers/net/dsa/mv88e6xxx.c
index da558d8..cd6807c 100644
--- a/drivers/net/dsa/mv88e6xxx.c
+++ b/drivers/net/dsa/mv88e6xxx.c
@@ -539,6 +539,54 @@
}
}
+#ifdef CONFIG_NET_DSA_HWMON
+
+int mv88e6xxx_get_temp(struct dsa_switch *ds, int *temp)
+{
+ struct mv88e6xxx_priv_state *ps = ds_to_priv(ds);
+ int ret;
+ int val;
+
+ *temp = 0;
+
+ mutex_lock(&ps->phy_mutex);
+
+ ret = mv88e6xxx_phy_write(ds, 0x0, 0x16, 0x6);
+ if (ret < 0)
+ goto error;
+
+ /* Enable temperature sensor */
+ ret = mv88e6xxx_phy_read(ds, 0x0, 0x1a);
+ if (ret < 0)
+ goto error;
+
+ ret = mv88e6xxx_phy_write(ds, 0x0, 0x1a, ret | (1 << 5));
+ if (ret < 0)
+ goto error;
+
+ /* Wait for temperature to stabilize */
+ usleep_range(10000, 12000);
+
+ val = mv88e6xxx_phy_read(ds, 0x0, 0x1a);
+ if (val < 0) {
+ ret = val;
+ goto error;
+ }
+
+ /* Disable temperature sensor */
+ ret = mv88e6xxx_phy_write(ds, 0x0, 0x1a, ret & ~(1 << 5));
+ if (ret < 0)
+ goto error;
+
+ *temp = ((val & 0x1f) - 5) * 5;
+
+error:
+ mv88e6xxx_phy_write(ds, 0x0, 0x16, 0x0);
+ mutex_unlock(&ps->phy_mutex);
+ return ret;
+}
+#endif /* CONFIG_NET_DSA_HWMON */
+
static int __init mv88e6xxx_init(void)
{
#if IS_ENABLED(CONFIG_NET_DSA_MV88E6131)