V4L/DVB (13374): AltoBeam ATBM8830 GB20600-2006(DMB-TH) demodulator
Adds support for Maxim MAX2165 silicon tuner.
It was tested on Mygica X8558Pro, which has MAX2165, ATBM8830 and CX23885.
Signed-off-by: David T. L. Wong <davidtlwong@gmail.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/drivers/media/dvb/frontends/atbm8830_priv.h b/drivers/media/dvb/frontends/atbm8830_priv.h
new file mode 100644
index 0000000..ce960f7
--- /dev/null
+++ b/drivers/media/dvb/frontends/atbm8830_priv.h
@@ -0,0 +1,75 @@
+/*
+ * Support for AltoBeam GB20600 (a.k.a DMB-TH) demodulator
+ * ATBM8830, ATBM8831
+ *
+ * Copyright (C) 2009 David T.L. Wong <davidtlwong@gmail.com>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; either version 2 of the License, or
+ * (at your option) any later version.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program; if not, write to the Free Software
+ * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
+ */
+
+#ifndef __ATBM8830_PRIV_H
+#define __ATBM8830_PRIV_H
+
+struct atbm_state {
+ struct i2c_adapter *i2c;
+ /* configuration settings */
+ const struct atbm8830_config *config;
+ struct dvb_frontend frontend;
+};
+
+#define REG_CHIP_ID 0x0000
+#define REG_TUNER_BASEBAND 0x0001
+#define REG_DEMOD_RUN 0x0004
+#define REG_DSP_RESET 0x0005
+#define REG_RAM_RESET 0x0006
+#define REG_ADC_RESET 0x0007
+#define REG_TSPORT_RESET 0x0008
+#define REG_BLKERR_POL 0x000C
+#define REG_I2C_GATE 0x0103
+#define REG_TS_SAMPLE_EDGE 0x0301
+#define REG_TS_PKT_LEN_204 0x0302
+#define REG_TS_PKT_LEN_AUTO 0x0303
+#define REG_TS_SERIAL 0x0305
+#define REG_TS_CLK_FREERUN 0x0306
+#define REG_TS_VALID_MODE 0x0307
+#define REG_TS_CLK_MODE 0x030B /* 1 for serial, 0 for parallel */
+
+#define REG_TS_ERRBIT_USE 0x030C
+#define REG_LOCK_STATUS 0x030D
+#define REG_ADC_CONFIG 0x0602
+#define REG_CARRIER_OFFSET 0x0827 /* 0x0827-0x0829 little endian */
+#define REG_DETECTED_PN_MODE 0x082D
+#define REG_READ_LATCH 0x084D
+#define REG_IF_FREQ 0x0A00 /* 0x0A00-0x0A02 little endian */
+#define REG_OSC_CLK 0x0A03 /* 0x0A03-0x0A05 little endian */
+#define REG_BYPASS_CCI 0x0A06
+#define REG_ANALOG_LUMA_DETECTED 0x0A25
+#define REG_ANALOG_AUDIO_DETECTED 0x0A26
+#define REG_ANALOG_CHROMA_DETECTED 0x0A39
+#define REG_FRAME_ERR_CNT 0x0B04
+#define REG_USE_EXT_ADC 0x0C00
+#define REG_SWAP_I_Q 0x0C01
+#define REG_TPS_MANUAL 0x0D01
+#define REG_TPS_CONFIG 0x0D02
+#define REG_BYPASS_DEINTERLEAVER 0x0E00
+#define REG_AGC_TARGET 0x1003 /* 0x1003-0x1005 little endian */
+#define REG_AGC_MIN 0x1020
+#define REG_AGC_MAX 0x1023
+#define REG_AGC_LOCK 0x1027
+#define REG_AGC_PWM_VAL 0x1028 /* 0x1028-0x1029 little endian */
+#define REG_AGC_HOLD_LOOP 0x1031
+
+#endif
+