bonding: don't permit to use ARP monitoring in 802.3ad mode
Currently the ARP monitoring is not supported with 802.3ad, and it's
prohibited to use it via the module params.
However we still can set it afterwards via sysfs, cause we only check for
*LB modes there.
To fix this - add a check for 802.3ad mode in bonding_store_arp_interval.
CC: Jay Vosburgh <fubar@us.ibm.com>
CC: Andy Gospodarek <andy@greyhouse.net>
Signed-off-by: Veaceslav Falico <vfalico@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bonding/bond_sysfs.c b/drivers/net/bonding/bond_sysfs.c
index bc8fd36..6245d92 100644
--- a/drivers/net/bonding/bond_sysfs.c
+++ b/drivers/net/bonding/bond_sysfs.c
@@ -524,8 +524,9 @@
goto out;
}
if (bond->params.mode == BOND_MODE_ALB ||
- bond->params.mode == BOND_MODE_TLB) {
- pr_info("%s: ARP monitoring cannot be used with ALB/TLB. Only MII monitoring is supported on %s.\n",
+ bond->params.mode == BOND_MODE_TLB ||
+ bond->params.mode == BOND_MODE_8023AD) {
+ pr_info("%s: ARP monitoring cannot be used with ALB/TLB/802.3ad. Only MII monitoring is supported on %s.\n",
bond->dev->name, bond->dev->name);
ret = -EINVAL;
goto out;