ARM: OMAP2: clock: Convert to common clk
Convert all OMAP2 specific platform files to use COMMON clk
and keep all the changes under the CONFIG_COMMON_CLK macro check
so it does not break any existing code. At a later point switch
to COMMON clk and get rid of all old/legacy code.
Signed-off-by: Rajendra Nayak <rnayak@ti.com>
Signed-off-by: Mike Turquette <mturquette@ti.com>
[paul@pwsan.com: updated to apply]
Signed-off-by: Paul Walmsley <paul@pwsan.com>
diff --git a/arch/arm/mach-omap2/clkt2xxx_virt_prcm_set.c b/arch/arm/mach-omap2/clkt2xxx_virt_prcm_set.c
index b9b981b..9a79ffa 100644
--- a/arch/arm/mach-omap2/clkt2xxx_virt_prcm_set.c
+++ b/arch/arm/mach-omap2/clkt2xxx_virt_prcm_set.c
@@ -59,7 +59,12 @@
*
* Set virt_prcm_set's rate to the mpu_speed field of the current PRCM set.
*/
+#ifdef CONFIG_COMMON_CLK
+unsigned long omap2_table_mpu_recalc(struct clk_hw *clk,
+ unsigned long parent_rate)
+#else
unsigned long omap2_table_mpu_recalc(struct clk *clk)
+#endif
{
return curr_prcm_set->mpu_speed;
}
@@ -71,7 +76,12 @@
* Some might argue L3-DDR, others ARM, others IVA. This code is simple and
* just uses the ARM rates.
*/
+#ifdef CONFIG_COMMON_CLK
+long omap2_round_to_table_rate(struct clk_hw *hw, unsigned long rate,
+ unsigned long *parent_rate)
+#else
long omap2_round_to_table_rate(struct clk *clk, unsigned long rate)
+#endif
{
const struct prcm_config *ptr;
long highest_rate;
@@ -94,7 +104,12 @@
}
/* Sets basic clocks based on the specified rate */
+#ifdef CONFIG_COMMON_CLK
+int omap2_select_table_rate(struct clk_hw *hw, unsigned long rate,
+ unsigned long parent_rate)
+#else
int omap2_select_table_rate(struct clk *clk, unsigned long rate)
+#endif
{
u32 cur_rate, done_rate, bypass = 0, tmp;
const struct prcm_config *prcm;