extcon: Add manufactor name of each extcon device
This patch adds the manufactor name of each extcon device
and removes un-necessary comment in Kconfig.
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
diff --git a/drivers/extcon/Kconfig b/drivers/extcon/Kconfig
index fdc0bf0..bd10b6c 100644
--- a/drivers/extcon/Kconfig
+++ b/drivers/extcon/Kconfig
@@ -36,7 +36,7 @@
extcon supports single state per extcon instance.
config EXTCON_MAX14577
- tristate "MAX14577/77836 EXTCON Support"
+ tristate "Maxim MAX14577/77836 EXTCON Support"
depends on MFD_MAX14577
select IRQ_DOMAIN
select REGMAP_I2C
@@ -46,7 +46,7 @@
detector and switch.
config EXTCON_MAX77693
- tristate "MAX77693 EXTCON Support"
+ tristate "Maxim MAX77693 EXTCON Support"
depends on MFD_MAX77693 && INPUT
select IRQ_DOMAIN
select REGMAP_I2C
@@ -56,7 +56,7 @@
detector and switch.
config EXTCON_MAX77843
- tristate "MAX77843 EXTCON Support"
+ tristate "Maxim MAX77843 EXTCON Support"
depends on MFD_MAX77843
select IRQ_DOMAIN
select REGMAP_I2C
@@ -66,7 +66,7 @@
detector add switch.
config EXTCON_MAX8997
- tristate "MAX8997 EXTCON Support"
+ tristate "Maxim MAX8997 EXTCON Support"
depends on MFD_MAX8997 && IRQ_DOMAIN
help
If you say yes here you get support for the MUIC device of
@@ -81,7 +81,7 @@
detection by palmas usb.
config EXTCON_RT8973A
- tristate "RT8973A EXTCON support"
+ tristate "Richtek RT8973A EXTCON support"
depends on I2C
select IRQ_DOMAIN
select REGMAP_I2C
@@ -93,7 +93,7 @@
from abnormal high input voltage (up to 28V).
config EXTCON_SM5502
- tristate "SM5502 EXTCON support"
+ tristate "Silicon Mitus SM5502 EXTCON support"
depends on I2C
select IRQ_DOMAIN
select REGMAP_I2C
@@ -110,4 +110,4 @@
Say Y here to enable GPIO based USB cable detection extcon support.
Used typically if GPIO is used for USB ID pin detection.
-endif # MULTISTATE_SWITCH
+endif