mac80211: add flag to indicate HW only Tx-agg setup support
When this flag is set, Tx A-MPDU sessions will not be started by
mac80211. This flag is required for devices that support Tx A-MPDU setup
in hardware.
Signed-off-by: Arik Nemtsov <arik@wizery.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index 2e752df..5e5029b 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -1096,6 +1096,10 @@
* stations based on the PM bit of incoming frames.
* Use ieee80211_start_ps()/ieee8021_end_ps() to manually configure
* the PS mode of connected stations.
+ *
+ * @IEEE80211_HW_TX_AMPDU_SETUP_IN_HW: The device handles TX A-MPDU session
+ * setup strictly in HW. mac80211 should not attempt to do this in
+ * software.
*/
enum ieee80211_hw_flags {
IEEE80211_HW_HAS_RATE_CONTROL = 1<<0,
@@ -1121,6 +1125,7 @@
IEEE80211_HW_SUPPORTS_CQM_RSSI = 1<<20,
IEEE80211_HW_SUPPORTS_PER_STA_GTK = 1<<21,
IEEE80211_HW_AP_LINK_PS = 1<<22,
+ IEEE80211_HW_TX_AMPDU_SETUP_IN_HW = 1<<23,
};
/**